Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I have officially exhausted pretty much all my google-fu trying to set this up so I'm asking my question here.

For the record, I am a mid level rookie who has played around with servers in his spare time but have never worked with Zentyal Server.

Now, I have been able to set up the server as a gateway, with one Network card being external and the other facing the internal Network.

The Internal network computers are able to access the internet without any issues.

What I need to do is to setup a open-vpn client on the central server so that all Internet data goes though the secure VPN session.

As far as I can see, I can't set up the vpn session through the web admin page.

Could somebody point me in the right direction? How would I go about doing this?

Regards

Shreyas

share|improve this question
    
Are you trying to set this up so you can establish a site-to-site VPN tunnel or allow external clients to VPN to your network and have their internet traffic go through you internet connection? –  Rex Jan 16 '13 at 7:56
    
Nobody will be connecting to the server externally. I just need all the internal internet traffic to be go over the VPN and not directly on to the servers regular internet connection. –  JustShrey Jan 16 '13 at 9:40
    
Essentially, If any of the internal network computers were to google whats my ip? , they need to see the ip of my vpn provider and not the external ip of my server. –  JustShrey Jan 16 '13 at 9:43
add comment

1 Answer

I'm on exactly the same quest. I can get Zentyal to connect to my VPN provider (which happens to be hidemyass (hma)), I can see that a tun0 interface is created using ifconfig, everything looks good.

But I can't figure out how to configure Zentyal to route traffic to it.

The closest I've googled is here: http://forum.zentyal.org/index.php?topic=12383.0

But I don't understand the response:

Just create two (2) network objects. 1. Certain host and 2. Other hosts. Then use bandwidth shaping, to route those traffic to the appropriate gateway.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.