0

On my Brocade FCX switch, I'm able to see syslog messages in-line when I'm using a console cable by running the command logging console from the configuration menu. However, when I SSH in, I'm unable to see the syslog messages in-line. On Cisco switches, I know the command is logging monitor to do this, but it doesn't seem to work on the Brocade FCX switches. Does anyone know the command to do this?

The firmware I'm running on is 7.4b. Thanks.

2 Answers 2

1

debug destination logging ssh < session number 1-5 >

Use show who to find your session number.

Reference

1
  • This does not work, it's possible to enter a debugging mode through a modification for this command (the above format is incorrect) but this does not enable general logging.
    – LandonWO
    Feb 1, 2013 at 22:07
0

So I talked to our reseller and found out how to do it.

First ensure logging is on and enable console logging

configure terminal
logging on
logging console

Then exit out of configuration mode and enable logging for ssh

exit
terminal monitor

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .