Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

Aim: To be able to access RStudio Server page from other internal PCs (all windows)

I barely know linux and everything I've done so far has been due to walkthroughs and the helpful responses to questions on this site. If anyone is able to point me in the right direction of what to do next I'd be a happy chappy!

Setup:
Windows 7 host
VirtualBox 4.2.10
Ubuntu 12.04 LTS Desktop
CNTLM installed with pointer to proxy with hashed credentials
Two network connections: 1) NAT 2) Bridged to it's own NIC
NIC MAC address and Bridged adapter MAC address matched
IPv4 properties coded with static IP details
Static IP's details registered on dns server

Details:
Ping enabled in UFW and service restarted
Port 8787 enabled on UFW (sudo ufw allow 8787) The host can ping IP
The guest can ping host
The guest can ping my PC
my PC cannot ping guest

Reply from myPCIP: destination host unreachable.

going to guestsIP:8787 gets

Internet Explorer cannot display the webpage

Outputs

sudo nano /etc/network/interfaces
auto eth0
face eth0 inet static
address 10.10.103.70
netmask 255.255.255.0

ifconfig
eth0 Link encap:Ethernet HWaddr 08:00:27:fc:33:d5
inet addr:10.10.103.70 Bcast:10.10.103.255 Mask:255.255.255.0
inet6 addr: fe80::a00:27ff:fefc:33d5/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:40 errors:0 dropped:0 overruns:0 frame:0
TX packets:109 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2400 (2.4 KB) TX bytes:15586 (15.5 KB)

sudo nano /etc/ufw/before.rules
-A ufw-before-input -p icmp --icmp-type destination-unreachable -j DROP
-A ufw-before-input -p icmp --icmp-type source-quench -j DROP
-A ufw-before-input -p icmp --icmp-type time-exceeded -j DROP
-A ufw-before-input -p icmp --icmp-type parameter-problem -j DROP
-A ufw-before-input -p icmp --icmp-type echo-request -j DROP

share|improve this question
    
Welcome to Server Fault! Your question is off topic for Serverfault because it doesn't appear to relate to servers/networking or desktop infrastructure in a professional environment. It may be on topic for Superuser but please search their site for similar questions that may already have the answer you're looking for. –  Dennis Kaarsemaker Mar 28 '13 at 0:29
add comment

1 Answer

up vote 1 down vote accepted

Turned out most of my problems were arising from an incorrectly configured floor port. Once this was correctly configured I was able to get the DHCP and gateway issues solved.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.