Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

Is it OK to replace 2 SAS HDs with 2 SSDs on a PE2900 with a PERC 5/i Integrated RAID controller?

In both cases, the drives are configured as a RAID 1 system volume (OS and programs).

In addition to the RAID 1 volume the RAID controller supports two RAID 10 data volumes, each consisting of four SAS HDs.

I read the post about installing 2.5" SSDs in the drive caddies of a PE2950; it seems that what I'm asking is physically possible. I'm wondering if SAS and SATA II can be combined on the same backplane and RAID controller.

Thanks.

share|improve this question
    
I ordered an Icy Dock and an Intel X25-E 64GB SSD from newegg. I will report back about if it works. –  sejong Aug 15 '09 at 22:46
    
The Icy Dock worked perfectly to physically interface the SSD with the hard drive carrier. I had to configure the SSD into a RAID 0 volume using the RAID controller BIOS, as opposed to the MegaCli command line utility because MegaCli did not recognize the SSD. –  sejong Aug 22 '09 at 6:56

2 Answers 2

SAS and SATA are compatible but run on different voltages, so to mix SATA and SAS drives on the same backplane your SATA drives require an interposer.

share|improve this answer

You lucky fellow.

I can't give you a straight answer, but I can point you here - this site mentions that you can obtain a cable to connect 4x drives to a SAS connector. I'm not sure of the specifics of your server, but it possibly already contains one of said cables?

share|improve this answer
    
Thanks for the suggestion, but in my case, I want to install the SSD in a hard drive carrier (caddy) in place of an existing HD, so I don't need the cables you mentioned. After reading several similar questions, I think the Icy Dock 3.5" to 2.5" hard disk adapter can be mounted to a hard drive carrier and will allow a 2.5" SSD to connect to the backplane when the carrier is put in its closed position. –  sejong Aug 15 '09 at 23:03

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.