Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

How to determine HP Smart Array model on HP server? I own HP 350 G6 server.

Really do not know where to look, is there a utility tool that can help me find this information, or is there a sign on the hardware?

Thanks

Ok, I used Array Configuration Utility and here is what I got

Internal Controller 
Controller Status OK 
Controller Smart Array P410i 
Slot 0 
Controller Serial Number 5001438018BF66A0 
Bus Interface PCI 
Hardware Revision C 
Firmware Version 5.14 
RAID 6 (ADG) Status Disabled 
Number of Ports 2 (Internal only) 
Number of Arrays 1 
Number of Logical Drives 1 
Number of Physical Drives 2 


Caching 
Cache Module Present Yes 
Cache Status OK 
Cache Ratio 25% Read / 75% Write 
Total Cache Memory Available 400 MB 
Total Cache Size 512 MB 
Cache Backup Power Source Batteries 
Battery/Capacitor Pack Count  1 
Battery/Capacitor Status OK 
Enable Write Cache When Battery/Capacitor Not Present or Not Completely Charged Disabled 
share|improve this question

2 Answers 2

up vote 5 down vote accepted

The controller model for that hardware can be found via the HP QuickSpecs technical specifications page. A quick search for "ML350 G6 quickspecs" reveals the quickspecs PDF and HTML pages for your server model.

All variants of the ProLiant ML350 G6 server used HP Smart Array P410 RAID controllers by default.

enter image description here

share|improve this answer
    
great, helped a lot. I have updated my question, so basically I have P410/512 MB BBWC? –  John Oct 1 '13 at 16:17
    
Could I use Array Configuration Utility to expand array? I believe I can.. –  John Oct 1 '13 at 16:47
    
Yes, that is correct. –  ewwhite Oct 1 '13 at 16:51

You can use the HP Array Configuration Utility. It should show you the model of the card installed and the current configuration. If you used the SmartStart CD to do an assisted install of windows, it should have been installed as part of the setup processes. Otherwise, it can be downloaded and installed separately.

You should be able to see the model of the card during the bootup sequence as well.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.