Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

Sign up
Here's how it works:
  1. Anybody can ask a question
  2. Anybody can answer
  3. The best answers are voted up and rise to the top

I do server setting from remote usually, but sometimes things went wrong, the server can't be connected from network anymore.

I've been disconnected from server with ip changing, firewall setting, bridge setting, etc. Every time I need to restore the server locally or ask someone who can do it locally.

I also write little script to restore server's connection, but sometimes the script also went wrong.

Any good idea that can help me avoid server disconnection?

share|improve this question

closed as off-topic by Jenny D, Falcon Momot, Dave M, Ward, mdpc Oct 2 '13 at 19:09

This question appears to be off-topic. The users who voted to close gave this specific reason:

  • "Questions must be relevant to professional system administration. Server Fault is a site dedicated to professionals; novice questions are off-topic. Please see the Help Center for more information on topicality. The best advice we can give you is to hire a professional to help you out." – Jenny D, Dave M, mdpc
If this question can be reworded to fit the rules in the help center, please edit the question.

up vote 3 down vote accepted

You should always have iLO/DRAC/ILOM configured. This is only way how to connect to server when things goes really bad.

share|improve this answer
iLO and the likes are life-savers, however, where I worked they ignored my requests for enabling iLO. So one day I had to change a route of a very remote server, it just hung. Luckily that machine had several NICs with different IPs/subnets configured, so I could log in on those and repair the primary NIC/IP-route. – Kent Oct 2 '13 at 9:45

For firewall changes, I often set an at job to run five minutes into the future, to turn the firewall off, eg with

# at now+5min
at> /sbin/service iptables stop

That way if the change I activate locks me out, I know in five minutes I'll be able to get back in. If the change goes fine, I can remove the job with atrm.

share|improve this answer
Similar advice works great on switches - set them to reboot in [x] minutes ('reload in x' on Cisco for example). If it breaks then it should revert to the previous config. – Dan Oct 2 '13 at 9:56

Whats the OS? If it's a linux based - Then you should have a console at your host company, or through your vmware which allows you to connect to your server even though network interfaces are down.

connect using the console then:

choose the appropriate interface (i'll use eth0): ethtool eth0 up

check you IP address and nic configuration: vi /etc/sysconfig/network-scripts/ifcfg-eth0

restart your nics: service network restart

then restart the machine with: reboot

share|improve this answer

Not the answer you're looking for? Browse other questions tagged or ask your own question.