Setting up Xen and Network Bridges on Debian 7
Hi there. So i am finally going to try out some virtualisation on my new dedicated machine, however i am having some problems / confusion on setting it up, so i will try best to explain my situation, and any help would be much appreciated.
To start, my server has ONE physical network adapter, eth0. The default configuration within /etc/network/interfaces is as follows
### Hetzner Online AG - installimage # Loopback device: auto lo iface lo inet loopback # device: eth0 auto eth0 iface eth0 inet static address 184.108.40.206 broadcast 220.127.116.11 netmask 255.255.255.224 gateway 18.104.22.168 # default route to access subnet up route add -net 22.214.171.124 netmask 255.255.255.224 gw 126.96.36.199 eth0 iface eth0 inet6 static address 2a01:4f8:191:2094::2 netmask 64 gateway fe80::1
However i also have a second IP allocation i purchased from my host, just to confirm i can successfully setup what i would like to do (Run roughly 3 virtual machines, each on their own external IP address) on my machine
The information for the second allocation is:
Address 188.8.131.52 Gateway 184.108.40.206 Netmask 255.255.255.248 Broadcast 220.127.116.11
I have installed bridge-utils as directed in the guide i have been following ( http://wiki.xen.org/wiki/Xen_Beginners_Guide#Preparation )
I then add my new bridge using
brctl addbr xenbr0
This is where i get stuck, or normally break my networking, which means i have to go into recovery and restore it to what it was originally, which is expected as i do not understand how this all works as of yet.
I am confused because i have seen some guides where you need to setup
iface eth0 inet manual and then configure the static ip on the
iface xenbr0 inet static and some where it is vice versa. Either way i have attempted has ended up in me breaking my networking as such
So, as a quick summary of what i would like too do:
- I would like to be able to assign each of my virtual machines their own external IP address
- I would like to have the dom0 using my first IP allocation (18.104.22.168) and my second machine (Which i am using as a tester) using my second IP allocation (22.214.171.124)
- I assume i have to use bridge tools to do this correctly? As the Xen guide suggests
I have not been able to find any tutorials which could guide a newbie through this, as i have not used / been into linux networking much, as my machines have always already had it completely configured and ready.
Thanks for any help or articles you point me towards