Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

We've currently got a HP ProLiant DL180 G6 server with a Smart Array P410i raid card, and 8 HDDs running off it.

We also just bought a new SATA Intel SSD drive to expand the server, that we're planning to connect to the motherboard's SATA ports..

Not the server's sata (powered by HP B110i), and the raid card on the server only support SATA 2. The SSD is a SATA 3 drive, which is backwards compatible, but we'll lose on data bandwidth.

Is there any way to get a SATA 3 port on the server, using an expansion card or something like that? Or does the server we have have no way of getting a SATA 3 port?

share|improve this question

1 Answer 1

up vote 2 down vote accepted

You don't have many options. Any SATA drive on a Smart Array P410 controller or the motherboard's SATA leads will only run at 3.0Gbps (or lower) speeds.

SATA 2 == 3.0Gbps SATA 3 == 6.0Gbps

You can use a different controller in the server, but none of the newer HP Smart Array controllers capable of running SATA at 6.0Gbps are compatible with that server. Other manufacturers do have offerings that may work.

In the end, this may not matter much. There's a bandwidth loss, but depending on your application, disk IOPS and latency tend to be more important than raw sequential throughput.

share|improve this answer
    
That's pretty much what I expected. I'm not worried much, but I did wonder if I could improve the sequential reads as well. Thanks a lot! –  Artiom Oct 12 '13 at 14:35

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.