Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

I installed my new drive and put Ubuntu server on it. It was working fine except ubuntu server was a bit to raw for me. So, then I decided to go back to my old drive and use the new drive as a second drive (the old OS was still on the old drive). The old ubuntu loads fine but it cannot see the new drive. I have tried putting the second dirve in all the SATA ports I have and I can never seem to see the drive.?

I run the following command to try and reformat it:

fdisk /dev/sdb

and I get the following error:

Unable to open /dev/sdb

I do not have to set any physical pins to let it know it should be the second drive right? Its not like the old IDE days. Is there a certain order to the SATA ports on the board?

Any thoughts on this would be much appreciated...

share|improve this question
    
What does "fdisk -l" say about what drives are seen in the system? –  Kevin Kuphal Aug 19 '09 at 6:06
    
Thanks for everyones help. You all had really good suggestions and I feal like a complete idiot for what it turned out to be. The power connection on the drive was loose! Once I got power to the drive things became much easier! Imagine that... Anyway I guess on the positive side is that I learned a lot about Linux drives! –  stephenmm Aug 24 '09 at 15:55

5 Answers 5

up vote 2 down vote accepted

Try:

fdisk -l

To list all disks and partitions, you could also check the boot log and see if the disk is detected there.

share|improve this answer
1  
sudo fdisk -l –  Dennis Williamson Aug 19 '09 at 14:29
    
sudo may have also been the missing piece. –  Broam Nov 19 '09 at 17:24

There is a certain order to the SATA ports, at least on the boards I've seen so far. The second disk might not show up as /dev/sdb but as /dev/sdc or /dev/sdd if you have 4 ports. But then, there might also be a problem with the disk itself.

share|improve this answer

As the previous have posted, you need to make sure you are pointing to the right disk...maybe look at gparted to see if the disk shows up?

this link might help > here <

hope that helps

share|improve this answer

A crude but information rich method of checking for your drive... does going through the kernel output show your drive being listed?

dmesg | less
share|improve this answer

Also check out dmesg to see what's happening as the system tries to initialize it. Is it even recognized in BIOS? If you can hot-plug it while the system is running, do tail -f /var/log/messages to see what's happening as you plug it in (then ctrl+C to end).

share|improve this answer
    
I guess by your suggestion that hot-plugging a SATA drive is safe? –  stephenmm Aug 19 '09 at 16:20
    
linux-ata.org/software-status.html#hotplug. Basically, your drive controller needs AHCI –  churnd Aug 27 '09 at 11:59

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.