Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I would like to use RAID1 with 1 SATA disk and 2 USB disks

PS: This is an ARM board (cubietruck) with only 1 SATA port and 2 USB ports.

PS2: The OS boots from a SD card :)

PS3: The setup does not aim for speed but for data reliability.

Edit: I removed the 3rd spare disk (over usb)

share|improve this question

closed as off-topic by SvW, Journeyman Geek, David Spillett, MadHatter, cjc Dec 22 '13 at 10:08

This question appears to be off-topic. The users who voted to close gave this specific reason:

  • "Questions must be relevant to professional system administration. Server Fault is dedicated to professional system and network administrators. End user and enthusiast questions are off-topic (contact your system administrator or hire a professional to help you out). Please see the Help Center for more information." – SvW, Journeyman Geek, cjc
If this question can be reworded to fit the rules in the help center, please edit the question.

    
Should this question go to superuser.com ? –  David Andreoletti Dec 22 '13 at 16:17
add comment

1 Answer

up vote 2 down vote accepted

I can't think of any pros.

The cons are:

  1. you're trying to make a RAID with disks on buses of two vastly different speeds

  2. you're trying to make a RAID with a bus that has notoriously poor low-level drive discipline options (USB)

  3. given the bandwidth limits of the USB bus, you would risk swamping the controller (particularly given that you want your spare on there) and corrupting the array regularly

  4. you're introducing a "spare disk" to a RAID 1 setup, which doesn't really make much sense (they're both already "spare" in a RAID 1)

Basically, you're taking one fast disk and two slow disks, slowing them all down to the speed of the slow disk, and limiting yourself to the size of the smallest disk, while introducing new points of failure, and getting no benefit from it that I can see. Just use the USB disks as backups.

share|improve this answer
    
Would it be better if the SATA port was not used to avoid swamping ? PS: I meant an additional disk to mirror to instead of spare. –  David Andreoletti Dec 22 '13 at 9:55
    
All of Bandrami's points are good. Either make backups, or check if tour SATA controller supports using Port multiplication and use two SATA disks. –  Hennes Dec 22 '13 at 12:10
    
@Bandrami: I will check for port multiplication. –  David Andreoletti Dec 22 '13 at 16:19
add comment

Not the answer you're looking for? Browse other questions tagged or ask your own question.