Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I just built a new Hyper-V host machine. I installed Windows Server 2008 R2 Datacenter, then installed the Hyper-V role.

Now, while trying to install a guest OS (2008 R2) the guest will first bomb out with a disk corrupt error (at aprox. 65% expanding files), then shortly after (30-90 sec.) the host will BSOD with a "PFN_LIST_CORRUPT" error.

I've run the Windows Memory Diagnostic, and updated all drivers. There aren't any BIOS updates available.

Is there something I'm missing?

share|improve this question
    
It ended up being defective RAM. –  Eric Haskins Aug 23 '09 at 23:35
add comment

2 Answers 2

up vote 3 down vote accepted

I had a similar issue to this (though; not a PFN under hyper-v) that was caused by a southgate that would send currupt bits when the chipset overheated. Are you running this on a quality server, or a cheap whitebox. Try running a memory test while doing heavy IO to try and heat up the board.

share|improve this answer
    
The processor and case temps are <40C, and the chipset heatsinks are cool to the touch, so I doubt that's the issues. I will test it like you suggest. –  Eric Haskins Aug 23 '09 at 4:01
add comment

With that ruled out, under those conditions, you should also check for voltage drop on each rail. (3.3,5,12...)

Low voltage conditions will affect memory consistency. Worst case scenario, run all drives and accessories from a second power supply and bridge the green wires. If you make it further, purchase a power supply with a 30-40% better wattage rating (minimum).

share|improve this answer
1  
Thanks for the post, but that issue was corrected 3 years ago. The PSU tested good at the time, and was already substantially overpowered. It ended up being a motherboard/RAM compatibility issue due to the RAM being higher voltage "performance" version. –  Eric Haskins Aug 14 '12 at 8:12
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.