3

According to this documentation it should be possible to configure a Cisco Switch by using the Puppet Module Device.

Where could this module be found?

Is this module restricted to Puppet Enterprise?

How to install it and run it in order to configure Cisco Switches?

Consulted sources:

Improve this question

1 Answer 1

Reset to default
2

There is nothing additional to install. On a node you configure /etc/puppet/device.conf with your switch information and then run puppet device on that node.

Improve this answer
3
  • Thank you for the answer. I will try this tomorrow or next week (the switches are located on my work) and let you know the outcome.
    – 030
    Jul 3, 2014 at 20:40
  • puppet device -d results in Error: Can't load cisco for device1: Connecting with ssh to a network device req uires the 'net/ssh' ruby library on both Windows as Linux. puppet --version => 3.6.2. After installing this library by executing gem install net-ssh the error persists.
    – 030
    Jul 8, 2014 at 14:15
  • Puppet issue has been created
    – 030
    Jul 9, 2014 at 8:42

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .