Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

Can't find anything online elsewhere, bought the piece on ebay used.. It's out of warranty, Cisco won't have anything to do with telling me how. HELP!

share|improve this question

1 Answer 1

up vote 2 down vote accepted

To reset the AP follow use the following steps:

Step 1 Disconnect power from access point. Step 2 Press and hold MODE button while you reconnect power to the access point. Step 3 Hold the MODE button until the status LED turns amber, and release the button. Step 4 After the access point reboots, you must reconfigure the access point by using the Web-browser interface or the CLI.

The initial IP address of the AP is 10.0.0.1 with DHCP server range 10.0.0.11 and 10.0.0.30

Source : http://www.experts-exchange.com/Security/Software_Firewalls/Enterprise_Firewalls/Cisco_PIX_Firewall/Q_23739350.html

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.