Take the 2-minute tour ×
Server Fault is a question and answer site for professional system and network administrators. It's 100% free, no registration required.

I have a hyper v server that I am connected to using remote desktop in full screen mode. Life is good.

I then connected to one of the virt machines in the and selected 'View | Full Screen Mode' which funnily enough, took me to full screen mode. That is, I have a full screen VM running inside a full screen remote desktop session.

However, pressing 'Ctrl+Alt+Break' simply maximises/restores the full screen mode of my original remote desktop session, without affecting the full screen mode.

The only sequence of events that seem to get me out of the full screen of the VM is: i) press 'Ctrl+Alt+End' which shows the Remote Desktop's equivalent of 'Ctrl+Alt+Delete' ii) Select Task Manager. This shows the Remote Desktop's Task Manager on top of the Full Screen VM, as well as showing the taskbar. iii) right click VM's icon on the taskbar and click close iv) re-connect to the VM from the Hyper-V manager

Is there an easier way?

(Yes, laugh all you want)

share|improve this question
add comment

3 Answers

up vote 2 down vote accepted

Whenever I nest RDP sessions or RDP -> VM sessions I always unstick the initial RDP sessions toolbar (clicking the tack icon will toggle it). This will cause it to slide out of view revealing the secondary connection bar of the nested RDP or VM window session. Now if you go three levels deep, you're on your own :).

share|improve this answer
    
:$ well, yes, I didn't even think to unpin the remote desktop session. Thanks everyone for holding in your mirth. –  cmroanirgo Sep 16 '09 at 22:40
add comment

You don't have the remote desktop tab at the top of the screen for the 2nd RDP session? I have one for the parent session, which slides up, revealing the 2nd tab, from which I can 'restore down' to a smaller window.

Best solution - this is easily justification for a larger screen, wherein you can run a non-fullscreen session comfortably. ;)

share|improve this answer
    
Thanks kara, although your answer is correct, I found Joshua's below a bit clearer. Note that I am using a 24-inch wide screen. The reason to go full screen is to get full keyboard support. –  cmroanirgo Sep 16 '09 at 22:42
    
You know, I like Joshua's answer better, too. ;) –  Kara Marfia Sep 17 '09 at 11:40
add comment

Ctrl+Alt+Pause should get you out of full-screen mode when using hyperV in full screen mode inside a remote desktop session.

share|improve this answer
add comment

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.