0

My Cisco Small Business RV110W Router reports wrong SNMP ifSpeed and ifHighSpeed values for eth0, vlan1 and vlan2 ( 10 Mbit/s instead of 100 Mbit/s ). This causes my SNMP management software to malfunction ( graphics are capping out flat at 10 Mbits/s ). ifSpeed and ifHighSpeed values are read-only, there is no way to correct that through SNMP.

I thought that maybe these values where dynamically adjusted under load, but they don't change.

I looked through the RV110W WebGUI for maybe a misconfigured interface ( 10Mbit/s instead of 100Mbit/s ), but didn't find anything like this.

Beside, eth1 and br0 get unset values ( 0 ).

Does anybody know what is happening here ? I'm all new to SNMP. Did I miss something ?

Thanks

Improve this question
2

0

Reset to default

You must log in to answer this question.

Browse other questions tagged .