4

I have a requirement to be able to determine how far Windows is through a sysprep sequence. After running sysprep /generalize we are creating an image of the OS which is then being used to create other VMs. When the created VM starts up, sysprep runs the specialize step and then the VM reboots. At this point the new VM is good to go.

The problem I am facing is that I have a sensitive application that should not run until after the specialize step has been performed and the machine rebooted (I have the source for the application so can make changes to make this happen).

The question is how can I determine that the OS is in this state. Are there some sysprep registry keys that can be read to determine how far through the process things are? Is is possible to tell when all the sysprep stuff is complete?

Improve this question

2 Answers 2

Reset to default
3

Look for setupact.log and setuperr.log files under the following paths:

  • C:\Windows\Panther
  • C:\Windows\Panther\UnattendGC
  • C:\Windows\System32\sysprep\Panther
Improve this answer
1
  • my setupact file is 3796 line!!!
    – AminM
    Jul 3, 2017 at 18:26
0

You could configure your application to not start on boot during image creation, then use config management like Salt or Puppet (or just a script) to set it to start on boot after a machine is fully deployed.

Improve this answer

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .