4

As part of my day-job I manage a couple of xenserver pools. I've been working through the old ones, bringing them up to xenserver 6.5 from a range of older versions 5.5, 6.0, 6.1, and 6.2

Many of the VMs now have an older version of xenserver tools installed. On the VM's General tab it says something like

 Virtualisation state:  Tools out of date (version 5.5 installed)
 Virtualisation state:  Tools out of date (version 6.0 installed)

Or confusingly

 Virtualisation state:  Optimised (version 6.2 installed)

What are the potential downsides for leaving the VMs as-is? Are there possible performance or reliability issues? This question is not about whether xentools should be installed, its aimed at whether updates to tools are important.

1
  • More than half of my VMs are windows servers, so upgrading xentools there is always at least one reboot, and may be as many as three. Linux VMs need some RPMs installed/upgraded, and that's it. No reboot is required even though the installer advises you to reboot.
    – Criggie
    May 19, 2016 at 1:15

1 Answer 1

2

Your drivers will be in legacy mode, simply as that.

An actual example from the competitor is like the e1000 (legacy) or vmxnet3 (optimised) in esx.

I manage some pool and with xendesktop its hard to stay uptodate with the xentool. (you have to reimage a virtual machine from the pvs to a machine on the xen and reapply the update and reimage back...) Thus for some customer I never did the update for large pool of VM due to time restriction. (desktop for my side)

I never seen stability issue, but I cant tell if it could run better.

The best place to answer your question is the 'whats fixed' of each release. (like there; http://support.citrix.com/article/CTX142583)

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .