Take the 2-minute tour ×
Server Fault is a question and answer site for system and network administrators. It's 100% free, no registration required.

Hay guys, I'm making a NAS for serving my files around my network. I bought a motherboard, a MSI KM4M-V Micro ATX. the spec says that it has "2 SATA 1.5Gb/s connectors". I'm however find these drives quite expensive. Would a SATA3 based drive work on this motherboard?

Thanks

share|improve this question

3 Answers 3

up vote 1 down vote accepted

SATA 3 drives are backwards compatible with 1.5Gbps controllers. Naturally the speed will be limited to the 1.5Gbps of the controller

share|improve this answer

You may get enough relevant information here: Is SATA 2 backwards compatible with SATA 1

The newer SATA drives will work, but you may have to set a jumper if you get an unlucky board/drive combination.

share|improve this answer
    
thanks, the drive im thinking of getting is a WD1002FBYS. any ideas if this will work? –  Dotty Nov 19 '09 at 14:50
    
Unfortunately I'm not familiar with drive specifics enough to tell you. The WD drive may have a "sata 1 mode" jumper or something similar; you should familiarize yourself with its location. You may not need to set it, though. –  Broam Nov 19 '09 at 17:23

At work we use WD SATA2 drives on boards that only have SATA1. I would look to see if it has four jumpers aligned like this : : : : and then you'll want to put a jumper on the second set from the left like this : [:] : : ... that is all we do at work and it fixes the problem.

share|improve this answer

Your Answer

 
discard

By posting your answer, you agree to the privacy policy and terms of service.

Not the answer you're looking for? Browse other questions tagged or ask your own question.