The tag has no wiki summary.

learn more… | top users | synonyms

0
votes
0answers
14 views

New Cisco AIR-1602I-E-K9 AP not working on some ports

I have had this problem since last friday but cannot solve it. I gave it a lot of thought so posting here is my last option/hope. We recently aquired 5 new Cisco AIR-1602I-E-K9, I configured them all ...
2
votes
1answer
110 views

Cisco AP vlan setup

I have been racking my brain since last night and all morning with this problem...luckily it's not in a production environment yet. I have done many searches and have come up with the same responses ...
1
vote
0answers
81 views

Force delay on apache response times

Is there a way to make an Apache response time to take at least 10 seconds? It's fine if it takes more than 10 seconds but I would like the fastest response times to take at least 10 seconds.
2
votes
1answer
1k views

D-link DAP-2590 VLAN configuration

So we have been fighting this issue for well over a year. It's been so long that I am having to relearn the configuration today. Here's the situation. We're running several D-Link DAP-2590's with ...
0
votes
0answers
264 views

Method to capture traffic going through a wireless router (802.11)

I am interested in monitoring and saving all wireless traffic going through a router (that includes the management frames sent from and the router too) but I am not sure what is the optimal strategy ...
0
votes
1answer
2k views

Cisco 881w AP factory reset

If I want to return to the factory IOS and configurations of the AP only, I must issue this command: service-module wlan-ap0 reset default-config right? But which IOS is going to replace the ...
1
vote
1answer
392 views

Reloading Cisco 881w AP reloads the whole router?

This is about a Cisco router (881w) with the AP-WLAN interface. While on the AP interface (after having entered this command:) service-module wlan-ap 0 session If I enter this command: reload ...
1
vote
1answer
830 views

How to interpret Cisco IOS web “signal to noise(dBm)”?

I notice a problem when viewing 802.11 (wifi) client status on a Cisco 1242AG AP. My question is about the "Signal to Noise (dBm)" field. I think that field should be called "Signal to Noise ...
0
votes
1answer
126 views

Cisco 350 Series AP Not allowing DHCP

I am installing a Cisco 350 Series AP into an envirnoment that has 2 existing Cisco 350 Series AP's. The devices (MC9090) can connect to the AP but the device is not getting an IP address. The Error ...
0
votes
3answers
433 views

can't find ip of wifi acess point

I setup an wireless AP (linksys wifi router) to have no dhcp and point to the main router as the default gateway. I also set it up to obtain a ip from the network but when i go to my main router and ...
0
votes
1answer
157 views

Wireless AP Placement and Digramming

I'm trying to research the best placement of wireless APs in a given space, and I'm running into problems in gathering information. I found (what I thought was) a great source in this tech republic ...