1
vote
1answer
115 views

Bonding more than 2 nics causes connection drops

I'm running CentOS 6.5. I have 3 servers with quad 1Gb nics. I'm using bonding mode 6 (tried 0 as well) running through a cisco 4948 switch. When only two network cables are attached, no issues. If ...
0
votes
1answer
285 views

NIC Bonding/balance-rr with Dell PowerConnect 5324

I'm trying to get NIC bonding to work with balance-rr so that three NIC ports are combined, so that instead of getting 1 Gbps we get 3 Gbps. We are doing this on two servers connected to the same ...
0
votes
1answer
235 views

Ksoftirqd high load

Recently I notice that one ksoftirqd is always in top of my processlist and takes 90% - 100% cpu. PID USER PR NI VIRT RES SHR S %CPU %MEM TIME+ COMMAND ...
0
votes
2answers
3k views

Linux Centos6 adapter bonding - Cisco 2960S EtherChannel LACP

I want to connect a CentOS 6.4 Linux Box with two NICs to a Cisco 2960S using LACP 802.3ad port aggregation. This mainly for redundancy reasons (and hopefully more bandwith). We don't use VLAN ...
4
votes
2answers
9k views

What is the correct way to setup a bonded bridge on Centos 6 for KVM guests?

What is the correct way to setup a bonded bridge on Centos 6 for KVM guests? I'd currently playing around with a setup of two KVM-hosts which will each host several guests. I have two HP DL380:s with ...
0
votes
1answer
604 views

No Gigabit NIC card in Xen 3.0 CentOS 5.6

I have a CentOS 5.6 linux host running two Windows Server 2008 R2 VMs in Xen. The problem I'm having is the NIC card in any VM shows up as 100Mbps and not 1000Mbps. I would like to be able to give the ...
2
votes
4answers
6k views

Bonding and default gateway problem (CentOS)

I configured network bonding on two machine with centos 5.5. Bonding works well, but the problem is default gateway: it is not configured! I follow this tutorial. I added GATEWAY in both (and either) ...
1
vote
3answers
2k views

Linux NIC Bonding Issue (CentOS 4 / RHEL 3)

I am having an issue with bonding NICs on CentOS 4. It appears the bonding driver does work, but it is stuck in round-robin mode and I am trying to get to active-backup. The current config is: ...