Configuration: Two switches, each with a separate internet route Centos servers with eth0 and eth1 bonded as an active-backup on bond0, eth0 in on switch and eth1 in the other /etc/modprobe.conf ...
I want to set up Hyper-V server according to the following: I want the Hyper-V server to, if both interfaces are up, to use the NIC connected to Switch A for storage traffic, and the NIC connected ...
I've read up a little bit on bonding nics with ifenslave; what I'm having trouble understanding is whether there is special configuration needed in order to split the bonds across two switches. For ...
First some of the details. We are a SME (80 office users 30 remote) with 2, soon to be 3 WAN connections. Our WAN connections are a T1, Cable (25/5), and soon to be DSL (10,2). We are looking to to ...
I'm setting up an offsite DR facility on a budget. The office has 2 ADSL lines coming in to identical router/modem devices. I'm looking for a cost effective (cheap) way of joining the two connections ...
We're using ESXi and I'm wondering about the "NIC Teaming" options for our vSwitches. On a particular vSwitch with 2 NICs, is there any GOOD reason for configuring a NIC as Active and the other as ...
I will configure a bond of three NIC's. I want to define which one will be first used and which NIC will be used as the second and third NIC when failover is done. Is this possible? Thanks
simple Question: how can i utilize two or more ethernet interfaces on target and initiator to have fail-over to use bandwith of all interfaces Answers? My Setup: both systems run linux and have ...