-1
votes
1answer
6 views

Cisco 877w - Brindging Dot11Radio & ATM to access the internet

I have a cisco 877w router, connected to ADSL internet line, what I'm looking for is to create wifi access point with the DOT11Radio interface so that client can access the internet from their phones ...
0
votes
1answer
1k views

Cisco 877 as PPPoA/PPPoE bridge (no routing) - how to make it listen to IP for management?

I have a Cisco 877 configured to bridge ADSL with PPPoA to PPPoE on Vlan1. This works fine, but in this mode the only way I can configure the Cisco is via the serial console. I'd like to have the ...
2
votes
1answer
119 views

Accessing WRT54G admin through WET610N bridge

I am using a WRT54G router to host a few computers and servers. I have another computer that is wired to a wireless bridge, which is a WET610N. How do I access the admin page of my WRT54G through my ...
0
votes
1answer
178 views

Cisco 871 IOS BVI: Distinguishing incoming and outgoing

I understand that a BVI is very much equivalent to a network switch. But it includes the benefit of being able to have an access control list. I am doing this, but I would like to more effectively ...
3
votes
1answer
2k views

Configure Cisco 877 as bridge between Internet and Cisco ASA 5505

ISP ADSL ---- Cisco 877 Router ---- Cisco ASA 5505 I have the above connection. I'd like to avoid using NAT on the Cisco 837 router, and just put the ASA directly on the Internet. However, I have ...
0
votes
1answer
50 views

Moving to Ethernet Extension / Short Haul Data - Do we route or bridge the existing subnets?

We currently have two sites connected via a vpn over a 4mb leased line. Site 1: 172.16.0.0/24 Site 2: 192.16.0.3/24 Thankfully the contract is about to end, so we are looking at upgrading to a ...
1
vote
3answers
340 views

bridge between vlans

We have a somewhat exotic setup. Some devices connected to a cisco switch must be administered by a third party and we don't want to give this third party full access to our network. There devices do ...
0
votes
1answer
569 views

Losing unicast traffic with “Input DA reject”

I have a rather complicated issue with an old Cisco 5509 Switch and a few kvm/qemu based virtual machines. First, the setup of the system looks like this: ...
2
votes
0answers
787 views

Site-to-Site IPSec VPN: bridged only

I'd like to setup a site-to-site IPSec VPN tunnel between a head office and a branch office, and for political/security reasons, with the sole purpose of being able to access a "Management" subnet at ...
0
votes
1answer
261 views

Cisco 1242 WAP Bridging

I'm looking to connect two facilities with a a pair of Cisco 1242 access points and am looking for advice on configuration. We have multiple VLANs running that will need to be passed through the ...