0
votes
1answer
76 views

Adding an interface-specific gateway

Desired result: Assign an interface-specific gateway in the circumstance that are also receiving general DHCP-supplied gateway settings. Current situation: Interface-specific gateway setting is not ...
0
votes
1answer
39 views

How is it determined which name server will be used for a particular interface?

According to the documentation for interface configuration files in RHEL 6, an interface can specify which name server it would like to use by including the directive DNS{1,2}=address . The ...
3
votes
1answer
224 views

Specifying which network interface to use

Assuming multiple network interfaces (eth0, eth1...), how can I specify which one I would like to use?: Can I specify per-application which network interface should be used? Can I specify ...
0
votes
0answers
485 views

Two servers on the same network can't ping eachother

According to this guide I setup two servers. Now these two servers can't ping each other, this is arp -n result: # arp -n Address HWtype HWaddress Flags Mask ...
0
votes
1answer
670 views

IP setting in CentoOS 6.2x64 by XenCenter 6.2

I have setup a Guest CentOS virtual machine in Xenserver.. I have updated the Xentools but i cannot find the option to config my IP Address which is showing to be 'unknown' currently. All i need to do ...
3
votes
2answers
713 views

How to Enable Full-Rights File-Browsing on /?

Now, I know there are lots of samba questions (about 1400) on ServerFault, and I have browsed through about half of them at least, and not been able to use any of the answers to solve my problem. We ...
2
votes
1answer
1k views

Centos 6.2 Fresh 'Basic Server' install networking issues

I've had a /29 provisioned on a network port for a server and am trying to at least configure the machine so I can ssh into it. It's Centos 6.2 x64 with the Basic Server install. Currently not able to ...
2
votes
2answers
244 views

Where to get network-files for centos?

I made a big mistake. Instead of typing : rm -rf /etc/sysconfig/network-scripts/ifcfg-eth0 I typed: rm -rf /etc/syconfig/network-scripts Can anybody help me to repair this mistake? Thanks in ...
1
vote
1answer
5k views

Setting a static route in CentOS

Here is my route -n output: Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.122.0 0.0.0.0 255.255.255.0 U 0 0 ...
3
votes
1answer
3k views

CentOS Client - Unable to Establish iSCSI connection with multiple interfaces on the initiator

So after upgrading to CentOS 6.2, I am seemingly no longer able to login into my iSCSI targets. I have multiple interfaces on different subnets on the system, and I first thought that it had to do ...