The tag has no usage guidance.

learn more… | top users | synonyms

-1
votes
0answers
7 views

iwconfig wlanX channel … - SET fails due to device being busy [on hold]

I'm using a Debian Jessie on a Sony Vaio VPCEB3M1E. Some information about my wireless card: :~$ sudo ifconfig wlan0 IEEE 802.11bgn ESSID:"********" Mode:Managed Frequency:2.412 GHz Access ...
0
votes
1answer
35 views

Do WiFi APs on same channel still interfere at a farther range (-70+)?

I am aware that the most common channels for the 2.4Ghz band are (1 ,6 ,11). They are non-overlapping. I also know that channel 6 is the default for most routers, if not set to auto. I am wondering ...
0
votes
0answers
63 views

interface not showing on port-channel (dell S5000 switch)

Our trunk went down due to a faulty cable, but when we had it replaced, the interfaces (speficially TenG 0/4 and /5) are not being shown on the port channel group even if they are physically up: Our ...
0
votes
1answer
33 views

wireless where to scan

I am using a wireless network scanner to analyze signal strength around my place and assign the best channel on my AP which is not overlapped with other APs. Where is the best place to scan; near the ...
9
votes
1answer
529 views

Freebsd change default Internet channel route

I have two Internet channel and Gateway on freebsd. When I switch channel with the command route change default chan2, the command netstat -nr shows changed default route. But traceroute shows that ...
5
votes
2answers
415 views

Using 4 wifi channels rather than 3

I have a wifi deployment with about 60 access points, currently limited to channels 1,6, and 11. This is a college campus, and the residence halls can get quite noisy, from an rf perspective. We ...
2
votes
1answer
745 views

Increase network bandwidth between 2 servers

Is it possible to increase the network bandwidth between 2 servers on Windows Server 2008 and Windows 7 ? For example : Use 2 Gigabit NICs on each computer to have 2 Gigabits/sec between 2 machines ? ...
13
votes
4answers
28k views

What happens when wifi channels overlap?

There are many pages on the web advising the use of wifi channels 1, 6 and 11 only, so that your wifi channels don't overlap. Obviously this makes sense when you only have your network do deal with, ...
6
votes
2answers
11k views

RHN Satellite / Spacewalk custom channels, best practice?

I'm currently setting up RHN Satellite, and all works well. I'm in the process of creating custom channels, since we have certain software which should be available for all nodes of satellite, e.g. ...