1
vote
1answer
21 views

Get information about inodes via snmp for linux

I want to check inodes via snmp for linux system, set up check. I could not find the correspondent MIB. Can any one help me to get information about inodes prozent ?
0
votes
1answer
2k views

nagios check_snmp ifoperstatus not OK

I'm reading Monitoring Routers and Switches page, in particular "Monitoring SNMP Status Information" section. quote: In the example above, the "-o ifOperStatus.1" refers to the OID for the ...
1
vote
2answers
3k views

check_snmp with snmpv3 protocol giving “Unkown Report message” error

I'm trying to add a nagios command to use snmpv3 for monitoring printer status messages. When using the check_snmp command, I get the following error: External command error: snmpget: Unknown ...
0
votes
1answer
158 views

Automatically adding comments to snmpd.conf

I have a snmpd.conf which looks like this. I would like the comments to auto-fill i.e. make the file human readable with explanations. If it were one file, I could have done copy/paste from default ...
2
votes
1answer
5k views

check_snmp warning & critical thresholds with negative values

I'm querying some signal level values measured in dBm, and the SNMP host on the remove device reports the values as negative values, ie, -90 dBm. However, check-snmp seems to be incapable of dealing ...