-2
votes
3answers
90 views

Cisco switch inter-vlan access

I have Cisco Catalyst 2960-s switch and I want to configure three Vlans (A; B; C) I want to : Allow traffic between A and B Allow traffic between A and C Block traffic between C and B or if ...
10
votes
2answers
379 views

Encryption over gigabit carrier ethernet

I would like to encrypt traffic between two data centres. Communication between the sites is provided as a standard provider bridge (s-vlan/802.1ad), so that our local vlan tags (c-vlan/802.1q) are ...
0
votes
2answers
689 views

XenServer 6.0.2 and Cisco 3550 vlan configuration

I am running a couple of xenserver 6.0.2 hosts with multiple vm's on them. All the xen hosts have 4 physical network ports connecting to the cisco. Each port is untagged in xen but is tagged to a vlan ...
0
votes
0answers
1k views

Trunking between Cisco 1800 router and Cisco Catalyst 2960 switch

I would like to establish trunk between Cisco router 1812 and Catalyst 2960 switch. What I would like to have is that router gets ip address on his fe0 interface and on fe2 provides trunk with 3 VLANs ...
1
vote
2answers
2k views

Vlan Management Policy Server ( VMPS) Configuration and Management

I am trying to design a topology in which I need to use VMPS and unfortunately the resources are rather few on the internet. Based on this Configuration document VMPS I have created a sample ...
1
vote
2answers
775 views

Management VLAN Cisco Catalyst

I have configured a couple of VLANs on a Cisco Catalyst switch with IOS, i will put all the ports that clients is connected to, into these VLANs. I want to configure the native VLAN [vlan 1] as ...
5
votes
1answer
496 views

Setting spanning tree link “priorities” in Cisco switches

I've got a pair of C2960G-48 switches (running IOS 12.2(46)SE, if it makes a difference) with redundant trunks in place. On these switches there are a bunch of VLANs that carry quite heavy traffic at ...