1
vote
1answer
189 views

multicast address use in corosync

I'm wondering about the purpose of the multicast address in the corosync messaging software : Since we have to bind each net interface with an IP address and a specific port, and each ring communicate ...
2
votes
1answer
197 views

NFS failover fails with stale file handles while migrating resources

Running into a bit of a problem here , I set up two servers ( Centos 6 ) with Glusterfs and a shared directory between them, I have moved the nfs directory to the shared Gluster folder and have ...
0
votes
2answers
276 views

Using DRBD with 100mbit uplink

we are planing to use drbd to sync two servers (different hardware) to get kind of HA in case the master server dies. The servers are hosted physically in the same datacenter (Hetzner in germany) and ...
0
votes
1answer
161 views

How to make active/passive jboss resource in pacemaker

I want to configure my pacemaker for jboss server. I have 2 nodes with mysql master/slave configured. The problem is I want to start jboss on node which is located master database. The one possible ...
0
votes
1answer
180 views

corosync binding to 127.0.0.1 instead of correct interface

I have the following problem when trying to implement a two-node failover cluster, using Hetzner as the hosting provider. my corosync.conf is as follows: # Please read the corosync.conf.5 manual ...
0
votes
1answer
164 views

corosync and multiple load balancers

I am trying to provide HA capabilities for our load balancers (nginx, pgpool and haproxy optionally) using pacemaker/corosync. I have defined three primitives: 1 for the failover IP, 1 for ...
-1
votes
2answers
1k views

corosync + pacemaker + nginx

I have been trying to configure and implement corosync + pacemaker + nginx to my vbox to create a High-Availability set-up between web servers. But can't find an exact tutorial on how to make it work ...
1
vote
0answers
626 views

Nginx Active/Active Cluster Setup

I am currently attempting to configure a pair of load balancing servers in an Active/Active configuration using the following: Nginx Corosync Pacemaker Applicable instructions were followed ...
6
votes
1answer
4k views

MySQL: Pacemaker cannot start the failed master as a new slave?

pacemaker-1.0.12-1 corosync-1.2.7-1.1 I'm going to setup failover for MySQL replication (1 master and 1 slave) follow this guide: ...
-1
votes
2answers
1k views

corosync active-active with 2 virtual IPs - clone constraints task

I have DNS roundrobin on 2 virtual IP in front of service. (Among others the service tested was: apache, nginx, varnish, postfix, … It really does not matter. Let's call it just service.) I ...
14
votes
7answers
16k views

Alternatives to Heartbeat, Pacemaker and CoroSync?

Are there any major alternatives for automatic failover on Linux besides the typical Heartbeat/Pacemaker/CoroSync combinations? In particular, I'm setting up failover on EC2 instances, which only ...