0
votes
1answer
48 views

looking for ftp client or web browser which can assign network interface

Does anyone know of an ftp client (or web browser), which allows me to specify (or assign) a network interface explicitly (like eth1 for example) during usage? Something for Linux would be good.
1
vote
3answers
1k views

How to Ping explicitly from eth1 instead of eth0

I'm trying to execute a ping with eth1, but the program uses eth0(the default network device). Any tips, tricks, or alternate techniques available?
3
votes
3answers
8k views

How to “restart” particular network interface on RHEL?

In RHEL, instead of using service network restart command, how can i restart a particular network interface, lets say "eth1", with only one command. "Only one command" because that is the only ...
1
vote
2answers
145 views

Cannot attach CentOS VMs via DHCP following router swap

I recently swapped out an old Netgear modem/wireless router and replaced with a ZyXel P660HW-T1 supplied by our ISP. I have configured it so that the new router has the same IP address, subnet mask, ...
0
votes
0answers
183 views

“Connection refused” after setting up IPv6 on Debian

I just set up IPv6 on Debian Squeeze on a hosted root server. Since I rebooted I can't connect to the server anymore. Ping is fine, but HTTP and SSH won't work. When I try to connect with SSH using ...
0
votes
3answers
554 views

Bridge ppp0 and eth0

I have seen many posts explaining bridging eth and wlan interfaces. I would like to know if it is possible to bridge ppp0 interface (a USB modem) and eth0. I have a working internet connection through ...
0
votes
2answers
3k views

Configuring Static IPs on CentOS 6.2

I am a complete Linux newbie, but we have quite a few spare Dedicated Machines available right now, so I decided to setup CentOS 6.2 on one of them and start getting more familiar with it. Obviously ...
0
votes
2answers
707 views

Fedora 15: em1 recently dissapeared and hostapd no longer serves internet to wirelessly connected devices

I have a laptop running hostapd, phpd, and mysql. This laptop uses an Ethernet connection to connect to the internet and acts as a wireless access point for my workplace's wifi devices. After ...
0
votes
2answers
886 views

Check by program if eth link is up or down on linux o.s. …and kernel 2.4

I need to check the change in the status of eth connection ( link up and link down ) by program ( using c or perl ). Now I using the keepalive way, but i sometime loose the notification. Inside the ...
2
votes
2answers
3k views

Bridging Network Devices with Multiple IPs

I have a small server with a single NIC that I am trying to get a bridge functioning on so that I can run KVM. On this NIC I have a couple IPs statically assigned to it: eth0 = 192.168.1.1 eth0:1 = ...
0
votes
3answers
591 views

Can't get an IP address

I'm running Ubuntu 9.04. I have an onboard network card. The computer usually boots perfectly, but today, I don't have an IP address. The light is on, on the network card as well as the switch. Other ...