The force10 tag has no wiki summary.
2
votes
1answer
65 views
Is it possible? - Have multiple DHCP ranges in a single subnet
I have a testing environment of 10 lightly-populated racks. I'll be installing a single 1 Gb switch in each rack with 10 Gb uplinks to a single central switch.
What I would like to have is for DHCP ...
-2
votes
1answer
86 views
Switch CISCO & Switch DELL Force10 [closed]
I have:
- a CISCO switch with VLAN 10 with an 10.0.0.1/24 ip
- a DELL Force10 switch with VLAN 20 with an 20.0.0.1/24 ip.
On VLANs, it's iSCSI request.
I would do to communicate the VLAN 10 & 20 ...
-1
votes
1answer
74 views
Which hardware gives us better redundancy, performance, and cost efficiency for a large Enterprise Cloud Solution? [closed]
We are going to build a Large Enterprise Cloud Solution and would like to know in which configuration we would have a better redundancy/performance and cost efficient.
Here are 2 examples which we're ...
1
vote
1answer
98 views
Policy Based Routing does not work on Force10 S50N
As soon as I turn on PBRs on our Force10 I'll get the following message:
%ACL_AGENT-2-USRFLOW_CAM_FULL: UserFlow Cam is Full
Any idea what that means?
Basically non of the PBRs are working so I ...
3
votes
2answers
324 views
How many Force10 “port channels” are needed for a VMware port group?
I have 3 ESXi hosts, each with 4 uplinks dedicated to a port group. I want to utilize each of these uplinks for incoming/outgoing traffic (load balancing).
From what I understand I need to setup link ...
1
vote
2answers
495 views
Force10 layer 3 switches
We've been running Cisco and dell layer 3 switches. The former are expensive and reliable, the latter a lot cheaper and fraught with issues. Anyone has positive experience with the core Force10 ...
0
votes
0answers
293 views
Force10 S4810 “Overlapping route for management interface”
We just got in a pair of Force10 S4810s and are getting tripped up on what should be a very basic configuration step.
The S4810 has a gigabit copper management port (though ultimately we'd like to ...
1
vote
0answers
280 views
PXE booting LACP hosts on Force10 S50N with FTOS
Hardware: S50N
Firmware: FTOS 8.4.2.6
Problem: We're trying to PXE boot some servers that are connected via port-channel interfaces with LACP.
Current Work-around: we PXE boot a server with a ...
0
votes
2answers
700 views
Force10 S60 remote management
We've got a Force10 S60 switch to replace an older Cisco. I can't find a way to give the switch itself an IP address on the local VLAN so I can ssh to it. The config guide talks about using either a ...
