-5
votes
1answer
421 views

ESXi 5.0 - Software RAID 1

Environment: Storage: HP P2000 MSA G3 SAS Array with 24 300GB 10k SAS Disks Two Storage Controllers with redundant SAS connections to each host Hosts: Three HP DL380 G7s with a 10GB SD Card, ...
0
votes
1answer
2k views

NAS4Free disk encryption and ZFS error

I have installed a NAS4Free on a VM, and as recommended, I installed it on a 1GB virtual disk, and assigned another disk 500GB to this VM for file storage. I have created the disk, encrypted it, ...
1
vote
3answers
1k views

Understanding the concept: Bare-metal VMware ESXi 5.0 with FreeNAS guest VM and iSCSI

I have a test setup (HP Microserver) with just a single disk at the moment and have ESXi 5.0 bare-metal installed on a USB flash drive and a FreeNAS 8 VM created as a 2GB install, but now I'm at a ...
4
votes
4answers
18k views

Disk IO slow on ESXi, even slower on a VM (freeNAS + iSCSI)

I have a server with ESXi 5 and iSCSI attached network storage. The storage server has 4x1Tb SATA II disks in Raid-Z on freenas 8.0.4. Those two machines are connected to each other with Gigabit ...
5
votes
1answer
1k views

Esxi with iSCSI SAN slows down with many multiple VMs running

I have a server with ESXi 5 and iSCSI attached network storage(4x1Tb Raid-Z on freenas). Those two machines are connected to each other with Gigabit ethernet, and a procurve switch in between. After ...
0
votes
0answers
564 views

Why has NFS suddenly started performing abysmally in FreeNAS 8

I've been using ESXi 5.0 quite successfully with my datastore provided by NFS share on FreeNAS 8. All of a sudden i'm experiencing terrible performance. I've ruled out some things: Hardware (FreeNAS ...
0
votes
2answers
383 views

Acquiring new servers to run ESXi and SAN/NAS

Here is our goal: Setup new servers to turn our entire physical computer network into 3 physical groups, which are: Server 1 - NAS - Openfiler/NexentaStor CE/FreeNAS/(Other Suggestions) ...
1
vote
1answer
1k views

Can single ESXi host make use of two separete iSCSI box?

I have problem with using multiply iSCSI targets with single ESXi host (in my case they are two FreeNAS hosts, but I suspect that this problem will occur with any two iSCSI box of that same ...
0
votes
1answer
704 views

FreeNas running on ESXi - sometimes gets very slugish

I have a ESXi server (dual quad core, 8GB of DDR3 ram, 6x 1TB WD Blacks running in RAid 5 on the PErc 6/i controller. I have a 64bit freenas VM running, on this VM I keep about 200Gigs of stuff that ...