Not sure if this is relevant to ask here ... but I cannot find any information on the net about it. But here goes: Today I have a fiber that comes into building B from A(I have no control here. Lets ...
I am attempting to set up a server with a total of four single-mode fiber ports - two need to be at least 1Gb and two must be 10Gb. I have found a variety of 10Gb single-mode fiber network adapters ...
I am trying to get an Gig-E network between two buildings that are approximately 260 ft. away. While some TRENDnet switches failed to be able to connect to each other over Cat 6 at that distance, two ...
Is 1000 Base SX fiber multimode (850nm) backwards compatible with 100 Base Sx fiber multimode (850nm)?
Is 1000 Base SX fiber multimode (850nm) interface backwards compatible with 100 Base Sx fiber multimode (850nm) interface?
This morning, I troubleshooted a fiber connection between two switches in the same building. It was a single-mode fiber. I knew this fiber was fine, because I had installed it myself and tested (with ...
I'm trying to build a laptop system that can connect to just about any network you might come across in a large enterprise. I realize I can use a media converter to go from twisted pair to fiber but ...