1
vote
1answer
45 views

HP ProLiant DL380 G5 BIOS Settings Wont Stay

Due to a damaged PCI-E interface, the motherboard was replaced on this HP ProLiant DL380 G5. Every boot the POST reports: System currently defaulted to typical configuration settings Any ...
0
votes
2answers
156 views

HP ProLiant Gen8 BIOS settings for VMware ESXi

What BIOS settings should be set on a HP BL460c Gen8 server so that ESXi 5.5 runs correctly?
2
votes
1answer
155 views

HP Proliant Gen8 boot failure after bios upgrade and processor upgrade

We have a HP Proliant DL360P with one Intel Xeon e5-2650, and we was in need to use two Xeon e5-2670 V2, this server by default this G8 did not recognizes the v2 processor, so we found this procedure ...
-3
votes
1answer
35 views

hp dl140 g3 how to repair after failed bios update

During updating bios to the new version (1.18) i got an error that computer can't read rom file. Then after reboot server did not start. Actually it starts but does not show anything, screen is blank, ...
1
vote
0answers
230 views

HP ProLiant DL120 G7 boot stuck due to disabled raid controller

After I have enabled RAID I disabled the B110i raid controller in the BIOS. Now it is stuck on a POST message and I can't do anything. Pressing F9 to re-enter the BIOS settings does nothing. It ...
3
votes
1answer
1k views

Flashing the BIOS on a DL380 G5 without Windows

This page has installation instructions for an update to the BIOS. Assuming our G5 does not have Windows on it, can someone enlighten me as to how this works? Does it make a bootable USB stick for ...
2
votes
1answer
975 views

How do I disable “Processor Power and Utilization Monitoring” on an HP ProLiant server?

I'm tuning my server for low-latency The guide suggests to disable this option "Processor Power and Utilization Monitoring" because: Disables iLO Processor State Mode Switching and Insight Power ...
1
vote
1answer
614 views

why ACPI SLIT is disabled by default?

I've found such option on my server: ACPI SLIT Preferences NOTE: This option is available on Gen8 servers with Intel processors. ACPI SLIT (System Locality Information Table) describes the relative ...
3
votes
2answers
3k views

How to make my HP server boot faster?

I have an HP ProLiant DL370 G6 server that I am using as a workstation. It takes 60 seconds during reboot and cold boot before screens post with a discrete Radeon HD6xxx GPU. What can I do to make ...
0
votes
2answers
706 views

Should I enable “Intel NIC DMA Channels”?

I have HP DL360p Gen8 646902-xx1 I'm trying to optimize my config for low latency trading. Should I enable "Intel NIC DMA Channels"? Will that help/affect my system? From HP doc: Added a new ROM ...
0
votes
2answers
3k views

Access HP Proliant DL385 BIOS [closed]

How do I access the BIOS of a HP ProLiant DL385 server? It doesn't have any hard drives, just power, monitor & keyboard connected. The keyboard is a PS/2 Microsoft Media keyboard with an ...
0
votes
2answers
1k views

HP Proliant ML115 G5 - Boot order lost after reboot

I have one HP Proliant ML 115 G5 (AMD) with the latest BIOS (07-06-2009) and recently I've installed an USB disk. This is a common problem on old Proliant servers. When you plug the USB disk, BIOS ...
0
votes
0answers
746 views

manufacturing fault : HP 630 laptop and BIOS version

We have received another returned laptop today from HP. The form explaining what HP have performed says they have upgraded the BIOS. I’ve checked the bios versions of all our 630 laptops and HP have ...
4
votes
2answers
3k views

Broken BIOS detected, complain to your hardware vendor. WTF?

This is what I found in dmesg on my new Fedora 16 instalation on new HP ProLiant DL320 G6 [ 0.130963] Performance Events: PEBS fmt1+, Westmere events, Broken BIOS detected, complain to ...
1
vote
4answers
11k views

HP Compaq 8200 Elite SFF won't boot from USB drive

Can't get an HP 8200 Elite Small Form Factor to boot from USB. It's done so in the past & the USB boot drive works in a different machine (HP 8440p laptop). Have tried upgrading BIOS (from 2.09 ...
0
votes
1answer
274 views

re-install hp dc7600

I inherited a used hp/compaq dc7600 desktop after we upgraded at work. The hard disk was re-formatted but it came with a set of HP XP and Restore disks - unfortunately for a dc5800. I optimistically ...
3
votes
2answers
2k views

unattended BIOS configuration for HP server (DL160SE G6)

We are having a big deployment of servers (DL160SE G6) and I need to find a way to configure their BIOS settings without going through the RBSU of each one - It would take too long. I am thinking ...
0
votes
3answers
5k views

HP DL380 G5 server BIOS Upgrade interrupted and no longer booting

Whilst in the middle of doing a maintenance CD and iLO upgrade via the iLO on a HP DL380 G5, lost connectivity to the server. After this point unable to contact the iLO. Will not ping. Unplugged all ...