0
votes
2answers
54 views

Getting an LSI SAS1064e to recognise new drives

I have an IBM x3200 M3 server running SBS2011. This server has an LSI SAS1063e controller (the basic BR10il RAID controller that comes with that system). Already existing was a RAID1 array of two ...
1
vote
2answers
209 views

M1015 pass-through and hot-swap in Linux with md raid (IBM x3620)

I'm setting up a small, but hopefully durable server for a student community, and the hardware is an IBM x3620 M3 with a builtin M1015 RAID card. To make the setup future proof and avoid vendor ...
1
vote
1answer
6k views

Access RAID configuration in x3550M2

I'm trying to configure RAID in a IBM x3550 M2 server. I can't find any messages on boot about any hotkey to access the configuration utility. I wasn't able either in BIOS. The card is a on board LSI ...
0
votes
2answers
2k views

Configure RAID for IBM X3630 X3

How can I setup a RAID for IBM X3630 X3 server with IBM ServeRAID M5015 disk drives? Is there a tool to configure disk drives? I'm using Windows Server 2008 R2
0
votes
2answers
2k views

Email alerts when RAID fails on IBM server?

Have two RAID controllers on an IBM server (X3500 M3) running Windows 2008R2: ServeRAID M5014SAS/SATA Controller LSI Adapter, SAS 3000 series, 4-port with 1064E Can anyone explain how to get email ...
0
votes
2answers
695 views

RAID Manager on Windows for IBM Server x-345

Good Morning, I have a IBM x-series 345 server with Windows Server 2003, I have a defunct drive which I would like to replace and rebuild the RAID while the server is up. I have been up and down in ...