The tag has no wiki summary.

learn more… | top users | synonyms

2
votes
0answers
273 views

iscsi disk over 2 TB cant initialized

I have a windows server 2012 x64. I'm free to connect and initialize the disks smaller than 2 TB. I can connect more than 2 TB disk but I can't initialize it? Windows can not determine its size, the ...
1
vote
2answers
212 views

iSCSI no longer recognizing NAS drives

I have two NAS (Seagate Black Armors) connected to our network through iSCSI to a Dell Optiplex 760 running 32-bit Windows 7 and Windows iSCSI Initiator. For some unknown reason, within the last week ...
0
votes
2answers
488 views

How to force iscsi initiator to login only once

Trying to setup a few CentOS nodes to connect to a Dell MD3600i array, i'm running into the issue that the MD3600i shows 4 different portals (with different IP addresses) and when i launch the ...
0
votes
2answers
322 views

Connecting to EqualLogic with Starwind Starport Initiator, login trouble?

We have a working iSCSI SAN, an EquallLogic, which runs fine with the Microsoft iSCSI initiator. With the Starport Initiator, we can't even connect. There's no login needed, neither local nor LDAP. ...
2
votes
0answers
795 views

Volume manager of Windows Server 2008 R2 does not show all iSCSI volumes

we set up a backup server (Win2k8 r2) for our VMware infrastructure which uses an iSCSI SAN for storage. The backup server has to be connected to the SAN for Veeam to be able to backup virtual ...
0
votes
1answer
154 views

Configure initiator on CentOS for two Targets

I have an old Promise VTrak M500i SAN Server. It comes with 2 iSCSI ports. I have given each port an IP: port1 - 192.168.2.12 port2 - 192.168.2.13 I have two Logical Drives on this SAN and ...
0
votes
1answer
1k views

iSCSI target volume does not show on Windows 7 iSCSI Initiator

I have a Windows VPS sitting in a DC and another Linux box sitting in another data centre. My Windows VPS (running on Windows 7 64 bit) have a small hard drive and cost a lot to upgrade, and the Linux ...
4
votes
2answers
1k views

Removing an iSCSI Target - iSCSI initiator 2.0 on Windows Server 2003 R2

For the life of me I cannot figure out how to remove an iSCSI target (Dell Equallogic SAN) from a Windows Server 2003 box. The volume shows up in Windows as drive letter Y:\ Using the iSCSI ...
2
votes
1answer
202 views

iSCSI target rebooting causes initiators to reboot as well

I'm running a couple of iSCSI Targets with OCFS2. I had to reboot my iSCSI Target (the physical iSCSI Target) due to some hardware changes and it caused all the initiators to reboot. I want to prevent ...