The operating system used on the majority of Cisco's routers and switches; a package of routing, switching, internetworking and telecommunications functions tightly integrated with a multitasking operating system. For Apple's mobile device OS, use apple-ios.

learn more… | top users | synonyms

7
votes
3answers
6k views

How to obtain Cisco IOS firmware?

Quick and simple question, but I've not been able to find an answer around. I have a Cisco ADSL router (model 877). I don't have any Cisco support contract. How can I obtain an updated firmware for ...
3
votes
2answers
5k views

QoS for Cisco Router to Prioritize Voice and Interactive Traffic

I have a Cisco 891W NATing Voice and Data to the internet over a 10mbit/2mbit connection. Voice traffic gets degraded when I upload large files. Pings time out as well. I tried to configure a QoS ...
6
votes
1answer
5k views

Why would Windows Server not respond to DHCP DISCOVER?

My network was working just fine and I broke it. There is a Cisco 1711 router which was configured to hand out DHCP leases to the client PCs. I have a domain controller (Server 2008) on the same ...
6
votes
4answers
1k views

Cisco IOS QoS prioritize SSH but not SCP

How can I prioritize ssh traffic to ensure low-latency but throttle SCP file transfers? I'm looking for a solution that is not host specific so I don't have to add lists of IP addresses. Thanks!
2
votes
2answers
3k views

Restoring a Cisco router config using a config file

I'm working with a Cisco router over telnet (actually PuTTY), and I'm a newbie to ios. I'm slowly getting the hang of it, but have a very basic question: I have issued a show running-config command ...
2
votes
2answers
2k views

Simple road warrior IPv4 VPN configuration in Cisco IOS

I'm looking to setup a reasonably simple road warrior VPN configuration on our Cisco routers. Frustratingly, I've been searching for this but cannot find a simple complete guide. Multiple (not ...
1
vote
3answers
4k views

What does the Cisco ASA command “management-access” do?

I'm working with a Cisco ASA 5510. I changed the management interface to a different interface. I used the command "management-access" to get the new interface working, but the old interface ...
1
vote
1answer
1k views

How to setup a static multicast ARP entry with Cisco SG300?

We're running a Microsoft NLB cluster in multicast mode as a loadbalancer. Using our old Cisco IOS switches we propagate access to the cluster to our branches using a static ARP entry in the core ...
0
votes
1answer
156 views

More than 8 classes in a policy-map - Cisco 3560

It appears I am limited to 8 classes per policy-map. Here is the error message when using the Cisco Network Assistant: The policy "policy-name" contains more than 8 policers, which means it ...
0
votes
1answer
279 views

Cisco IOS ACL: Don't permit incoming connections just because they are from port 80

I am going much based on my memory and I may not be correct on all of this. On a Cisco 851 (IOS) that uses a BVI or a bridge-route (the servers on the inside are configured with static and public IP ...
0
votes
1answer
2k views

IOS NAT with multiple interfaces

I am trying to create a DMZ type environment between two internal networks using Cisco NAT. The below configuration is working to permit the two 'nat outside' interfaces to access the dmz 'nat ...