0
votes
0answers
447 views

Need advice on Juniper OSPF networking

I have been thrown in to this project because of a coworker's termination. I have a set of Juniper SRX 550 Routers. I need to create an OSPF network that passes all traffic (All subnets) as if it ...
0
votes
1answer
45 views

Juniper with multiple DHCP pool connected to Cisco switch

Newbie question: In our law office we have the following setup: Juniper SRX connected to Cisco L3 switch via trunk port. Cisco switch has: VLAN 5 range: 10.4.0.10 - 250 /24 VLAN 6 range: ...
-3
votes
2answers
300 views

Access to vCenter Server (in private network) from the Internet through vSphere Client [closed]

I have a vCenter server as a VM on my DPER710 in my internal network. DPE is connected to switch, switch is connected to JSRX, JSRX is connected to my ISP. My vCenter Server is installed on Windows ...
2
votes
1answer
663 views

How to get Juniper SRX220 to respond to multiple IP Addresses

How can I get an SRX220 to respond to multiple ip addresses on same subnet, but with different gateways. e.g., Subnet: 1.1.1.40/30 (.41 gateway, .42 actual ip) Subnet: 1.1.1.44/30 (.45 gateway, .46 ...
1
vote
1answer
2k views

SRX220: Cant ping between hosts in directly attached networks through SRX

I have such lab: SRX220H and 2 hosts. Host1 (IP-address 192.168.1.100/24) connected to SRX interface ge-0/0/1 (interface address 192.168.1.1/24); Host2 (IP-address 10.10.1.100/24) connected to SRX ...
0
votes
2answers
107 views

Is there a Juniper limitation on the number of SA in 'any to any' ACL in IKEv1

I've connected Juniper SRX5800 and another enodeB device (don't know the vendor) by an IPSec tunnel. It uses IKEv1 for negotiation of keys. there are 10 ACLs on the enodeB side and on Juniper SRX, I ...
0
votes
1answer
1k views

How to route all network traffic for vlan through a proxy server on SRX

I'm trying configure an SRX router to automatically forward all traffic through a proxy server i have in the USA. I have created a separate vlan and configured the proxy but not sure how i can route ...
0
votes
1answer
406 views

Packetloss in Juniper SRX with gigether-options loopback enabled

I have run into an interesting problem with a Juniper SRX 240 box. The box is running BGP as a border router, and is announcing a /24. To ensure that the vlan with the network stayed "up" I set the ...