1
vote
1answer
196 views

Any problems with having an active/active HAProxy setup with Keepalived

Apologies if this has been asked before, but I can't seem to find much on it. We're going to be using HAProxy to load balance our MariaDB Galera Cluster. All the articles/tutorials I have seen on ...
1
vote
1answer
471 views

View Current State of Keepalived

Is there a way to view the current state (Master/Backup) in a command line on a server instance? Thanks.
0
votes
1answer
2k views

HAproxy 503 Service Unavailable No server is available to handle this request

I'm new to this load balancing scenario and I'm being tasked to figure out how to make this load balancing works. My environment: Centos 6.4 64 Bit Webserver: Lighttpd All running in ESXI virtual ...
0
votes
0answers
107 views

Can keepalived use a dedicated NIC for VRRP traffic only?

I have a pair of Linux load balancers for a single VIP, 10.13.10.227. They run keepalived and haproxy. They are connected directly to each other (no switch between them) on each other's eth3 and have ...
0
votes
1answer
281 views

keepalived doing a lot of TCP DUP ACK and TCP Retransmission

I'm trying to replicate the setup our hosting provider have done for our load balancer, which is using keepalived. So I have one "load balancer", running CentOS 6 and keepalived 1.2.7, with two Web ...
1
vote
2answers
498 views

Per-packet round-robin load balancing for UDP

I need to load-balance UDP traffic between a number of "realservers" and do it in a truly round-robin fashion. I've started with keepalived, but unexpectedly discovered, that LVS treats UDP traffic as ...
0
votes
1answer
74 views

IP-based load balancing on external and internal interface

I have a certain distributed (as in, multiple components on multiple machines) service, that should be made available from the outside world. So, in LVS terminology, the clients are "on the internet", ...
0
votes
1answer
461 views

Keepalived in ring architecture, or other better approach

I have three load balancer (LB1, LB2, LB3) and plan to use ring architecture for active-active setup, e.g. LB1 LB2 LB3 IP1 IP2 IP3 Idea as below: If LB1 failed, IP1 will be floated to ...
1
vote
1answer
125 views

Why state is needed for keepalived

From the doc ! MASTER and BACKUP state are determined by the priority ! even if you specify MASTER as the state, the state will ! be voted on by priority (so if your state is MASTER but your ! ...
1
vote
1answer
355 views

Compare HTTP load balacing using HAProxy & Nginx

My requirements: Weighted RR load balancing NO need sticky session support NO need SSL NO need HTTP 1.1 to backend So effectively I just need very simple HTTP load balacing!! My Boss asked to try ...
1
vote
1answer
375 views

Loadbalance nginx proxies with keepalived possible?

I was wondering if I could load balance 2 nginx proxies with keepalived. I have already established high availability for 2 proxies in MASTER - BACKUP setup with keepalived. So Failover is working ...
0
votes
1answer
483 views

Keepalived configuration - To set MASTER/BACKUP or EQUAL

Now this is something which has been on my mind since I started stetting up our load balancers. Would you use the MASTER/BACKUP configurations for keepalived if both your HAProxy servers were the ...