1
vote
1answer
365 views

LSI MegaRAID SAS 9261-8i: Disk isn't recognized after replacement

I've got a Supermicro Server with an LSI MegaRAID SAS 9261-8i Raid Controller inside. There were 3 Disks attached to the controller which were configured as RAID5 array. One of the disks failed ...
1
vote
0answers
118 views

running commands on physical drives on different backplane with megacli

So when I run "MegaCli64 -PDlist -aALL -NoLog | egrep 'Slot|state|Inquiry|Enclosure'" to grab a list of disks and their status. I can see a total of 36 disks. The issue is that they have the same slot ...
2
votes
4answers
587 views

LSI RAID: Write cache policy affects read performance?

I have a server with a LSI MegaRAID SAS 9260-4i controller, RAID-5 with 3 x 2 TB disks. I did some performance testing (with iozone3) and the numbers show clearly that the write cache policy affects ...
3
votes
1answer
329 views

Migrating RAID6 array from HP SmartArray P600 to LSI MegaRAID SAS 8888ELP

My customer has an external RAID6 array (8x 1TB in HP MSA60 enclosure) attached to HP SmartArray P600 controller. They have now decided to replace the server and the new one comes with LSI MegaRAID ...
0
votes
1answer
375 views

RAID: replacing a disk before it fails

We have a RAID 5 setup (Megaraid SAS ROMB) with 4 930 Gb physical disks running as a 2.7 TB VD. Recently (a few months back) we had a drive fail and had to leave it in degraded mode for ages (various ...
1
vote
0answers
176 views

Possible bad raid card / hard disks (LSI 9261-8i)

I am in a bit of bad spot at the moment, i have a dedicated server hosted by someone else, it has a LSI 9261-8i raid card installed, attached is: 3x300GB SAS 15K rpm disks (in RAID5) 5x2TB SATA ...
1
vote
2answers
217 views

Horrible performing RAID

I have a small GlusterFS Cluster with two storage servers providing a replicated volume. Each server has 2 SAS disks for the OS and logs and 22 SATA disks for the actual data striped together as a ...
2
votes
2answers
966 views

MegaRaid damaging disk by set a drive to “Offline”?

I wanted to test performance in a RAID10 with a "damaged drive". To simulate this situation I've set a single drive to "Offline" by using this command: MegaCli -PDOffline -PhysDrv [45:12] -aAll The ...
3
votes
1answer
775 views

Megaware Raid 10

I have 22 disks and would like to create a Raid 10. Unfortunately my raid controller (MegaRAID SAS 9260-8i) is only capable to handle 8 arrays within a RAID 10. Because of that I could only use 16 ...