0
votes
2answers
80 views

MTU between Juniper and Cisco, cause of packet loss?

This office has a network consisting of Cisco Catalyst and Juniper EX L3 switch. Cisco Router and Juniper L3 switch share a OSPF area in between them. Hosts on Juniper side are running FTP servers ...
1
vote
1answer
293 views

Cisco IPSEC VPN Slow Speeds

We have a site to site IPSEC VPN, both endpoints are Cisco PIX 515e's. The links at both end are 100mb, however speeds over the VPN (logged using jperf) are at most 4mb. Obviously this represents a ...
3
votes
1answer
1k views

PIX 506E, MTU, VPN Packet Fragmentation and Shoretel IP telephone system

We have two sites, a large Southern site and a small Northern site, that have a VPN between them defined on two Cisco PIX Firewalls. Over this VPN Shoretel IP phone traffic travels as well as all ...
1
vote
1answer
170 views

System MTU for SAN switch

I have a SAN with redundant cisco 2960s when I set it up a while ago I set all of the interfaces to use an MTU of 9000. I was looking at the config today and I noticed this line system mtu routing ...
0
votes
1answer
762 views

Optimal MTU settings ADSL for PPPoE over ATM/LLC

Is 1446 optimal for PPPoE over ATM/LLC as this forum post describes?