1
vote
1answer
675 views

Configure LeftHand iSCSI SAN for jumbo frames after clients are configured

This is similar to enabling jumbo frames on an iSCSI network after the fact but in our case we configured the switches and then went through all the hosts, enabling jumbo frames (we may have screwed ...
1
vote
1answer
170 views

System MTU for SAN switch

I have a SAN with redundant cisco 2960s when I set it up a while ago I set all of the interfaces to use an MTU of 9000. I was looking at the config today and I noticed this line system mtu routing ...