4
votes
1answer
529 views

Mounting a disk from SAN (RHEL 5.9)

Storage admin told me he put a 3TB drive on my server from the SAN and I was asked to mount it. The only information I know is that it's on LUN 1 and that the disk is 3TB. Multipath is setup and I ...
1
vote
1answer
421 views

How to make sure RHEL will see multipath disks after a reboot?

We are using RHEL, but unfortunately there are issues with multipathing. It seems not all SAN disks are automatically seen after a reboot. A service multipath reload is required in order for the OS ...
1
vote
1answer
4k views

RHEL 5 How to set mount location of multipath device?

I have a RHEL5 + 3Par FC SAN storage environment and am unsure how to setup a multipathed FC device to mount to particular location like /data. I have the 3Par Implementation guide for RHEL and it ...
1
vote
2answers
329 views

Multipath performing very poorly RHEL/HSV200

I'm running a RHEL 5.5 with multipath@HSV200 storage system. The disk performance for write is VERY poor comparing to Windows-system counterparts (which are using the same storage and multipath). ...
6
votes
2answers
603 views

Implications of 100% utilization on dm device

We have a RHEL 5.6 server here with 4 active paths to a single LUN. We suspect that it's not able to cram enough IOs down the pipeline to the XIV on the other end: mpath0 (XXXXXXXXXXXXXXX) dm-9 ...
0
votes
1answer
402 views

Same hard disk reported twice in Red Hat (SAN and multipath)

I use two Q-Logic HBA's on one server which have access to the same LUN. Red Hat (and gparted also) sees the LUN as two seperate disks (sda, sdb). Is this normal? Thanks!