0
votes
1answer
106 views

using pf for packet filtering and ipfw's dummynet for bandwidth limiting at the same time

I would like to ask if it's fine to use pf for all packet filtering (including using altq for traffic shaping) and ipfw's dummynet for bandwidth limiting certain IPs or subnets at the same time. I am ...
0
votes
1answer
207 views

pf not execute udp port specific block rule

The traffic I want to block can be sniffed as below with tcpdump: 19:16:22.391164 IP 95.95.95.95.2036 > 10.10.10.10.443: UDP, length 8192 So I wanted to write a rule block any udp destination ...
3
votes
2answers
3k views

Create a rule using shell in fresh pfSense installation to open up WAN access to WebConfigurator

I am in a situation where I require WAN access to be opened up to the WebConfigurator through pfSense because I do not have another node connected to the same network to access WebConfigurator from ...
0
votes
1answer
752 views

pfSense to ASA L2L VPN - infrequent, short-lasting, but consistent disconnections

Has anyone here been able to specify a stable configuration for the L2L VPN between an ASA device and pfSense 2.0.1? I am using the most accomodating settings on the ASA side (DefaultL2LGroup with ...
0
votes
1answer
655 views

Order of application of NAT rules in pfSense 2

In pfSense 2.0, I have a bunch of WAN CARP Virtual IPs and a bunch of 1:1 NAT rules defined associating these IPs to LAN subnet hosts. If I set up Port Forwarding rules that forward from CARP IPs ...
0
votes
2answers
2k views

Slow upload speeds with pfsense virtual appliance

I have a pfSense virtual appliance set up in front of a Windows server. The pfSense appliance has been configured with two L2L IPSec VPN sites and not too much else. The appliance has two vNics which ...
7
votes
3answers
1k views

OpenBSD/FreeBSD Firewall w/ GUI that is compatible with Intel 82574L Gigabit LAN NICs

I recently purchased a server to run m0n0wall or pfSense but I've learned since then that both of these firewall products are based on versions of FreeBSD which weren't yet compatible with the NICs in ...
0
votes
2answers
293 views

using “include” like statement in pf.conf to include some parts from other files

I want to be able to include some parts of my pf.conf from other set of files. For example I will include "set timeout" vs like statements in another file. Using anchors and "load anchor from ...
3
votes
1answer
99 views

blocking packets larger then specific size with pf

Is there a way with pf to block specific type of packets larger than specific size?
0
votes
2answers
772 views

carp versus proxy arp

Currently I have a redundant pfSense firewall system set up for our corporate server farm. The main router IPs are sharing an IP address through Carp. Our two public /27 networks are assigned as ...