2
votes
1answer
23 views

Error in PREIN scriptlet in rpm package quagga

I am trying to install quagga on my Linux server and I am getting below errors: Error in PREIN scriptlet in rpm package quagga-0.98.6-11.el5.x86_64 error: %pre(quagga-0.98.6-11.el5.x86_64) scriptlet ...
0
votes
0answers
53 views

NetKit - Multiple tap interfaces

I have a computer with 4 physical ethernet interfaces (2 netcards). I am trying to use NetKit in order to simulate a networking system (BGP+OSPF+MPLS+...), however I cannot emulate everything, I will ...
0
votes
1answer
1k views

Prevent Quagga from a certain subnet advertising

I have an Ubuntu 12.10 workstation with the following interfaces: eth0 : 10.11.1.15/24 lo:1 : 10.90.50.50/32 lo:2 : 10.1.100.100/32 tap0 : 10.5.200.200/24 As you can see, all IPs fit in 10.0.0.0/8 ...
0
votes
1answer
571 views

default route propagation under rip - quagga

How would I propagate a default route under RIP, from a router? The operating system is Ubuntu. Can this be done in Quagga? What would be the command? I found a solution for a cisco router: ...
1
vote
3answers
935 views

Tough routing problem with Linux, Quagga and OpenVPN

The Setup I have an OpenVPN server that acts as a central router. It is configured with "topology subnet" command. Clients are Debian Linux nodes and each have one (or more) subnets directly ...
4
votes
1answer
737 views

Quagga keeps announcing down routes

I have set up BGP on two routers using qugga. When I down the interface that holds the IP block that I am advertising zerba removes the route from its table but bgpd keeps advertising it. I can see ...
0
votes
2answers
332 views

What does ./configure --disable-zebra in the Quagga suite stand for?

I am currently configuring Quagga. Quagga is an routing suite for Linux. I was suggested to use --disable-zebra when configuring Quagga (./configure --disable-zebra). Does anyone exactly know what ...