0
votes
2answers
60 views

Raid 5-Disk Faulty [closed]

I have the following Raid-5 Configuration with one disk faulty. http://i62.tinypic.com/2z6rxck.png I need to do a swap out. Not sure with the current configuration if it will affect the other disks, ...
0
votes
1answer
474 views

BAD stripes in controller and windows utility to remap bad blocks

Ok, here is my story. I have 3 disks raid 5, one of the disks made a few surface errors and I didn't know. I tried to repair the corrupted database table in mysql and the machine froze on write. I ...
1
vote
1answer
1k views

Cannot reactivate RAID-5 volume: The size of the plex member is invalid

We had a 3-drive Windows Server 2008 R2 RAID-5 fail (operating in redundancy mode): WDC 1 TB WDC 1 TB WDC 1 TB We removed the failed hard drive, and put a WDC 1 TB drive (that we had standing by) ...
0
votes
2answers
278 views

Failed Redundancy for RAID 5 Disks

I'm facing difficulties in regards to some disk issues if you guys can help me. I am using Windows Server 2003 for my File Server. For the past few days in Disk Management the status of two of my ...
1
vote
1answer
253 views

Add Automatic hot spare to Windows raid5

Ive been searching all over and cant find anything on this subject. I have a Raid 5 configured in Server 2003 using 3 1.5Tb drives, I have a 4th drive I want to add as a hot spare and I would need to ...
3
votes
1answer
678 views

Configure Windows RAID-5 “drive failed” timeout?

When a hard-drive controller detects an error, and needs to remap a sector, the drive normally becomes unresponsive for the seconds (or possibly minutes) it takes to try to complete the re-mapping. ...
0
votes
1answer
739 views

Windows 2008 R2 raid 0 over hardware raid 5

I am consider using windows raid 0 and raid 1 over two hardware 4x2tb raid 5 arrays. (thinking Seagate green drives). 2x Rocketraid 2680 controller but that could easily change. So, that would give ...
5
votes
3answers
1k views

How do I calculate the disk subsystem i/o capacity

I am trying to figure out the number of 8K page i/o capacity for a disk subsystem. The drives are SATA 7200 RPM - 4 drives in a RAID-5 configuration. I am not sure about the SCSI controller but the ...
0
votes
2answers
1k views

Windows 7 Mount Software RAID 5 array

I have a server that died, though the drives appears fine. There are four of them, with a 10GB mirrored volume for the boot, and the rest as a RAID5 array spread across the four drives. When I connect ...