It has always seemed a bit strange to me that the console ports on networking gear are 8P8C (popularly referred to as "RJ45" even though that's not strictly applicable here) connectors and require an ...
I have two Cisco 2901 GWs, each has an HWIC-2T interface module. I want to set them up back-to-back to send network traffic between PCs and Phones connected to my GWs over this link. I have ...
I have just received a new IBM switch, a G8000R. It's written on the guide it is necessary to establish a connection between switch and hyperterminal console. So I have connected the switch via a ...
May sound like a stupid question but just wanted to make sure. Does every serial connection need to have its own IP address. Router 1: Serial 0/0/0 IP address 126.96.36.199/30 Serial 0/1/0 IP address ...