Tagged Questions

0
votes
1answer
17 views

SIP (G.711) packets getting out of order

I have 2 asterisk servers on 2 different datacenters. Call is going from one to another. Suddenly audio quality decreased. I have made SIP traces on both servers. Here's what I've found: Server A ...
0
votes
1answer
75 views

Troubleshooting a failing SIP connection

I have a linux Asterisk server that is behind a firewall. The firewall has three interfaces : eth0 is the LAN, where Asterisk resides, eth2 is the default gateway to the internet (via an ADSL modem ...
0
votes
1answer
157 views

Networking issue with asterisk server

I replaced an IVR machine for incoming call after going down. It is running asterisk 1.4.23 on ubunutu 10.04 I decided to put the server behind iptables because my server was under brute force attack. ...
0
votes
0answers
83 views

SIP/Asterisk: Withheld number from client not set to withhold the number

I'm using PJSIP (a command line SIP client) to make calls on an Asterisk server (IP: 11.22.333.44). When calling from the PJSIP client (number 12323) to another extension (12315, a Snom phone), that ...
0
votes
0answers
144 views

Not able to register via SIPclient on asterisk server?

I'm unable to register a SIP client on my Asterisk server. What changes do I need to make to my Asterisk server configuration to fix this? Here are my configuration files for Asterisk. sip.conf ...
1
vote
1answer
95 views

Asterisk Connection not working

I have installed Asterisk on VirtualBox by following the steps from here. Everything went ok until I got to navigate to an IP to configure Asterisk using FreePBX: 10.0.2.15 (Shouldn't be something ...
2
votes
1answer
1k views

Inbound SIP calls through Cisco 881 NAT hang up after a few seconds

I've recently moved to a Cisco 881 router for my WAN link. I was previously using a Cisco Linksys WAG320N as my modem/router/WiFi AP/NAT firewall. The WAG320N is now running in bridged mode, so it's ...
0
votes
1answer
197 views

asterisk peer with SIP provider through proxy

I'm trying to make a asterisk server connect to a SIP provider (which offers PSTN origination and termination). I've been reading the great Definitive Guide, but it doesn't seem to cover the case ...
0
votes
1answer
98 views

can't register a soft phone to asterisk11

I have a VM (on oracle vbox) running Fedora17. I've installed asterisk 11 on it from sources. I've followed the wiki for installation (https://wiki.asterisk.org/wiki/display/AST/Creating+SIP+Accounts) ...
0
votes
0answers
344 views

Can't register SIP clients to asterisk11 server on Fedora [closed]

I have a VM (on oracle vbox) running Fedora17. I've installed asterisk 11 on it from sources. I've followed the wiki for installation (https://wiki.asterisk.org/wiki/display/AST/Creating+SIP+Accounts) ...
1
vote
1answer
99 views

Provisioning SIP Phones over the internet

I have a few SIP Phones that are located of site and connect to my PBX over the internet to make calls. For some reason one of these phones has become unprovisioned. In my office phones get ...
0
votes
1answer
107 views

Asterisk dialplan context and label clarifications

I have been learning Asterisk dial plan for the past week.I have written down a simple IVR system with two levels of menu and an exit option.I have used concepts from different tutorials on the ...
1
vote
1answer
189 views

Configuration of a Cisco IP Phone 7916 and 7975g

Hi everyone, I would appreciate some help configuring my Cisco IP Phone 7975. In fact the phone works well with the SIP firmware (version SIP75.8-4-1ES2) and an Asterisk Server. Now I would like to ...
3
votes
2answers
492 views

How can I make Asterisk keep track of dynamic SIP agent statuses?

I am setting up a new server using Asterisk 1.8.11-certified4. In testing, we're seeing that agents dynamically logged into the queue will receive a second queue call as a call-waiting when ...
1
vote
0answers
300 views

Lync 2010, Kamailio, & Trixbox 2.6.23 (Asterisk 1.4)

I'm having an issue trying to connect Lync 2010 phone calls with our trixbox PBX. I've gotten to the point where Kamailio seems to be functioning properly and acting as a bridge between TCP traffic ...
3
votes
4answers
5k views

How to stop registration attempts on Asterisk

The main question: My Asterisk logs are littered with messages like these: [2012-05-29 15:53:49] NOTICE[5578] chan_sip.c: Registration from '<sip:912@xx.xx.xx.xx>' failed for '37.75.210.177' - ...
3
votes
1answer
2k views

Asterisk SIP/2.0 401 Unauthorized

I'm running into a funny little issue with Asterisk 10.3, but it seems to be applicable to 10.4 as well. The server running Asterisk was relocated from a VPS to dedicated hardware, and now only 1 of ...
0
votes
2answers
953 views

Asterisk: Authenticated SIP trunk

Let's say I have an Asterisk system with a bunch of connections: there are phones (who register itself with *) and providers (who wish to establish SIP trunks to put a lot of calls over, with ...
0
votes
2answers
2k views

Asterisk + SIP 404 not found

I want to make a small Asterisk server in my house. I installed asterisk on my Ubuntu and I use 2 computers, in order to connect to one another. when I connect I can see in Wireshark that registrar ...
1
vote
0answers
246 views

Asterisk 1.8, Dedicated SDSL but SIP Provider Inbound Channel heavily delayed?

We have a dedicated Asterisk 1.8 server running as a front end SIP server for authenticated and internal users only, using SDSL 2MB/2MB, in the UK. The provider of our internet also is the provider of ...
1
vote
1answer
188 views

Asterisk IVR to Extension slow

I have a IVR set to pickup our PSTN lines and tell the user to enter the extension OR to press 1 for a representative. If the person enters an extension it transfers within 1 second , but if they ...
0
votes
1answer
235 views

how UAC should handle SIP 183 Session Progress

I have the following scenario: 2 UAC are trying to talk, via a remote SIP server (openSER/Kamailio 3.1.3) = client infrastructure. The UAC software was developed over a local test infrastructure ...
0
votes
1answer
576 views

Sip configuration for Elastix, for Terrasip (Provider) with Multiple DIDs

I have just purchased several DIDs with Terrasip I have configured my Elastix (freepbx) SIP trunk according to their suggestion: Please follow this template configuration. (valid for outbound/inbound ...
2
votes
1answer
182 views

how is the voip network working when server is outside nat and clients are inside nat?

I want to install an asterisk on a server with a public ip. The sip clients are behind different NATs. How is the signaling and the rtp packets (the voice) working in this case? Will rtp be peer to ...
0
votes
2answers
105 views

how to associate an ip with a name?

I have installed an asterisk on my private network(so it s behind a router ). Is there anu way to set the asterisk on a public ip though it's installed in a server with private ip? As Ive read it ...
0
votes
0answers
181 views

Is it possible to split Asterisk SIP signaling and voice traffic?

How do I configure Asterisk to send SIP signaling to one IP address and the RTSP stream, voice traffic, to another address?
0
votes
2answers
2k views

Asterisk - inbound calls from SIP DID trunk “rejected because extension not found”

I have a DID with DIDforSale that's pointed at my Asterisk server. When I call it from my landline phone I get the AT&T disconnected line recording. The Asterisk CLI shows the error message: [Oct ...
1
vote
2answers
497 views

Asterisk DID incoming rules =s

So I have a 10 way SIP trunk from a UK provider. Calls in and out work fine, but as I have multiple numbers for different purposes I set up the inbound rules for each number but they never work, only ...
1
vote
1answer
337 views

SIP ( Asterisk ) CoS solutions with no VLAN's?

I have a Asterisk box actually two running pure asterisk. No GUI i.e. FreePBX, TL etc. The asterisk box is connected to a an EX4200 VC Stack, the EX4200's then connect to our headquarters via a Qwest ...
2
votes
1answer
506 views

Adding more than one IP to sip.conf tcpbindaddr and udpbindaddr (Asterisk 1.8)

The defaults in the sample sip.conf under Asterisk1.8 contain udpbindaddr=0.0.0.0 and tcpbindaddr=0.0.0.0. I want to bind the incoming [foo] extension to udp:192.168.1.1/255.255.255.0, the outgoing ...
3
votes
4answers
544 views

Asterisk Intrusion Prevention

Let me start of by saying that I'm a noob, and what I've figured out so far has only been by stumbling my way through it. I have Googled around and the solution may be out there already, but it was ...
0
votes
2answers
1k views

Asterisk Incoming Calls Don't Route to Extensions

We have just setup Asterisk 1.6 with FreePBX 2.8. We configured SIP Trunks with our Polish SIP Provider (a total of 3 trunks) in the system. Using a softphone registered to the only extension in the ...
13
votes
2answers
577 views

not able to register sip user on red5server, using red5phone

I start the red5, and then i start red5phone i try to register sip user , details i provide are username = 999999 password = **** ip = asteriskserverip And I got -- Registering ...
0
votes
1answer
176 views

Test-service on Internet for testing incoming INVITE

I am trying to set up Asterisk at home. I think I'm having trouble configuring my firewall, so that inbound traffic is accepted, but I am not sure. I got the idea that, perhaps, there is a service ...
0
votes
2answers
468 views

Asterisk Server with SIP Account Routing to Cell Phones

I'm having trouble finding the exact documentation to do the following: I have a SIP Account. I want my Asterisk Server on a VPS somewhere in the United States to accept the credentials of the SIP ...
2
votes
1answer
715 views

asterisk/freeswitch in nat/no-nat setup

my current setup - i use bunch of sip hard-phones around few offices. all devices have two sip accounts configured - one on internal sip proxy [for calls between the branches], another - at 3rd party ...
1
vote
0answers
41 views

add presence for a remote user to a legacy telephone system?

we have a small call center that uses an old nortel phone system with analog lines. one of our sales people works from home so her calls do not go through the phone system. this creates a problem at ...
0
votes
1answer
1k views

Asterisk, IAXModem & Hylafax how-tos?

I'm trying to set up Asterisk and IAXModem to send faxes via T38 (Yes, I know I'm swatting a fly with a Buick...) However, since I'm trying to do something so small with a product so large, I'm having ...
2
votes
2answers
6k views

Asterisk SIP digest authentication username mismatch

I have an asterisk system that I'm attempting to get to work as a backup for our 3com system. We already use it for a conference bridge. Our phones are the 3com 3C10402B, so I don't have the issue ...
1
vote
1answer
796 views

FreePBX: Basic config?

I've just successfully set up an Asterisk+FreePBX install on an Amazon EC2 instance per this guide: http://voxilla.com/2009/10/15/voxillas-freepbx-in-a-cloud-step-by-step-1457 (I've also assigned it ...
2
votes
2answers
279 views

VOIP Codec Preference

Do any of you have a preferred codec for VOIP traffic? I guess this is another case where the answer varies depending on use case, equipment, topology, etc... I'm trying to find an optimal codec to ...
5
votes
2answers
1k views

Ways to monitor SIP termination on an asterisk server

I have a nagios setup which ensures that SIP is responsive on my Asterisk server, that's straight forward. My question is, what kind of possibilities are there that the Asterisk server can actually ...
1
vote
2answers
1k views

Asterisk terminating outbound call when picked up, sends 'BYE' message

I'm running Asterisk 1.6.1.10 / FreePBX 2.5.2.2 and I've got an outbound trunk setup. Everything use to work fine until recently (perhaps due to upgrade to FC12 or other things I'm not sure). Anyway ...
3
votes
6answers
876 views

What bandwidth would be required for 55 VOIP Lines And what type of Internet connection

In a call centre environment, what bandwidth would be required for 55 lines? This would be on SIP protocol, would we be best to use G729 codec as i know that our sip provider supports this? What type ...
0
votes
3answers
4k views

How to connect a Fritz!Box as a SIP client to Asterisk

My planned setup is as follows: Analog Fax machine -> Fritz!Box -> Asterisk -> Telephone network My problem is, how do I convince the Fritz!Box to connect as a SIP client to my Asterisk instance?
7
votes
4answers
1k views

Skype-SIP gateway

Does anyone know if you can setup a Skype-to-SIP gateway on your network? I tried Uplink, which works wonders, but only on Windows and with Skype on the same machine... It would be awesome if you ...
1
vote
1answer
1k views

How to configure Gizmo5 on Trixbox/Asterisk

Does anyone know how to configure Gizmo5 for use on an Asterisk PBX? Specifically Trixbox if possible. For the life of me I just can't get this to work...
1
vote
5answers
671 views

Is there a stable cross-platform softphone? Or a Linux-only one?

We use an Asterisk based solution as our PBX, and although we've found hardphones work flawlessly, we have yet to find a reliable softphone. The basic requirement is that it allows multiple calls and ...