0
votes
0answers
36 views

How do I make Cisco phones use <user>@<domain> instead of <user>@<ip> in SIP messages

I am using Cisco 8000 and 9000 series IP phones and registering them to Opensips. The problem is that I want to communicate with the proxy using @ instead of @ so I can have multiple domains on one ...
0
votes
0answers
57 views

Connect Cisco IP phone on two Asterisk sip servers

I have a cisco ip phone with sip firmware v9.3.1. I want to connect two lines on two seperate Asterisk sip servers. In section i can only define USECALLMANAGER (in node) and not the IP of an ...
0
votes
0answers
264 views

Configure SIP Trunk from Lync 2013 to Cisco Call Manager v6

I'm implementing Enterprise Voice for Lync, and I have to get Lync to work with a antiquated Cisco Call Manager version 6. The SIP trunk has been created but I get this error on my Lync servers: A ...
0
votes
1answer
2k views

Cisco ASA 5505 - NAT or Port Forward for SIP / VoIP ver 8.4

I just had an NEC PBX installed that lets me use SIP trunks for VoIP services, My gateway is a Cisco ASA 5505 running 8.4 and I only have one public/static IP Addresses. So far, my trunks are ...
0
votes
0answers
42 views

Tool to remove irrelevant sip messages from debug

I have a trace file of a cisco ccsip messages debug. Since this is taken on production, a lot of call that don't interest me are included. I want te easily filter out only one specific call-id, and ...
3
votes
2answers
5k views

Inbound SIP calls through Cisco 881 NAT hang up after a few seconds

I've recently moved to a Cisco 881 router for my WAN link. I was previously using a Cisco Linksys WAG320N as my modem/router/WiFi AP/NAT firewall. The WAG320N is now running in bridged mode, so it's ...
1
vote
1answer
168 views

Provisioning SIP Phones over the internet

I have a few SIP Phones that are located of site and connect to my PBX over the internet to make calls. For some reason one of these phones has become unprovisioned. In my office phones get ...
1
vote
1answer
405 views

Configuration of a Cisco IP Phone 7916 and 7975g

Hi everyone, I would appreciate some help configuring my Cisco IP Phone 7975. In fact the phone works well with the SIP firmware (version SIP75.8-4-1ES2) and an Asterisk Server. Now I would like to ...
1
vote
1answer
274 views

Can a Cisco AS5350 be used as a Session Border Controller (ip-to-ip)?

And how can it be configured as such? We don't need transcoding or anything like that, just something between our switch and the internet.
0
votes
0answers
999 views

SIP through VPN has one-way audio

I'm struggling with a SIP installation with a remote user. THe phone boots up, provisions itself from the (remote) TFTP server, performs SIP registration with the PBX, and I can make calls to the ...
0
votes
1answer
916 views

How do I configure the SIP source interface on a Cisco router so that it sticks?

I manage a cisco router acting as a SIP gateway. In order to get it to register to the SIP provider, the connection needs to come from the right IP address. This is done with the following lines in ...
3
votes
1answer
140 views

Does anyone know a good Website comparing all the PBX/IP telephone solutions?

I'm looking for a good website dressing a comparative analysis of the most popular telephony solutions resellers (Cisco, Avaya, Siemens, Microsoft, etc...). I already found a very nice work comparing ...