0
votes
0answers
23 views

Do you need STP on ProCurve trunks?

We have 3 switches - a Core Switch, and 2 downstream switches. Each downstream switch has a 3 cable Trunk direct to the core switch. However - when we disconnected one cable in that trunk group ...
1
vote
1answer
53 views

ProCurve Trunking

We have 3 switches at the moment - see the diagram below for NOW. Essentially the CORE switch is 7, and 8 and 9 have a 3 cable trunk each to 7. Now, we want to add Switch 5 to the equation - see ...
3
votes
1answer
660 views

HP Procurve Core Switch Architecture

I want to build a new 'core' for our network. We currently have a 3com 4060 switch acting as the core, connecting all the other TOR and access switches together. The goal is to add resilience into ...
5
votes
1answer
727 views

Procurve Primary VLAN

I'm trying to depreciate usage of VLAN 1 on my ProCurve switches; 1 is unused. I understand that VLAN 1 must exist, but I want to remove it from all ports, especially trunks between switches. The ...
2
votes
1answer
727 views

Setup VLAN agnostic ports on HP ProCurve 1810G (Ingress Filter, Trunking)

I am wondering if it is possible to configure some ports of the web managed ProCurve Switch 1810G to participate in all VLAN traffic. Even if no VLAN with that ID has been set up inside the switch. ...
8
votes
3answers
2k views

HP Procurve Issue Passing Multiple VLANs over a link

Just to start off with I am a Cisco guy that got placed into an HP project. Basic topology overview from outside in: ASA 5505 with two Ethernet connections to a 2610 switch. This switch is then ...
3
votes
2answers
7k views

HP Procurve 1800 Switch-to-Switch Trunks and LACP (and VLANs too!)

I am considering connecting two (and possibly three) HP Procurve 1800 switches together with trunks or with LACP. I can't find any substantial answer to my questions via Google or here. I did find ...