0
votes
0answers
28 views

Untangle running on ESXi sending tagged VLAN to Cisco switch not working

basically here is my setup: [Host A] = A hypervisor running ESXi 5.0 [Switch A] = A Cisco 2960-S Series 48 port switch [Switch B] = A Cisco 2960-S Series 48 port switch [P-Router] = *A physical ...
1
vote
1answer
682 views

ESXI 5.1 - Losing access to management interface on vSwitch1 when vSwitch0 loses network access

I'm probably missing something obvious here, but, I am trying to make some adjustments to the Vkernel Port management interface on vSwitch0 that is set to VLAN ID: All (4095). So I don't disconnect ...
1
vote
1answer
813 views

ESXI 5.1 - Unable to trunk to cisco switch

I have configured my esxi host vSwitch1 to use the secondary NIC on my VMware host. On vSwitch1 configuration I have set the VLAN to 4095 which specifies to allow all VLANs. If my cisco switch port ...
-1
votes
1answer
309 views

link aggregation in esxi5 + aggregation on the switch + freebsd9 = an aggregated link that do not work

i have a 6 port intel server nic. under the settings on ESXi5, i aggregated 4 of the ports. i have ZFSGuru running on the VM, which is based off of FreeBSD 9, iirc. this VM has two interfaces, an ...
0
votes
1answer
405 views

What is the best way to connect a dual LAN server to two trunked switches?

In an older quetion "Best practice to trunk two GB switches?" I asked about how to trunk two switches. I now used a static link to connect them and it runs well. Now I am not sure on how to connect ...