-2
votes
0answers
24 views

Installing Wi-Fi in a bus and connecting the server form a college to the bus [on hold]

How do I share my internet from a server at my college to a moving bus that moves about 30 miles in radius around the server? I need to install a Wi-Fi modem in the bus. What are all the technical ...
0
votes
0answers
9 views

use wireless router with with wired router [on hold]

I have a Tendnet 1.1g wireless router. I also have a cable modem the wireless router is connected to now. In order to get a VPN access for my home network, I bought a netgear FVS318v3 Cable/DSL ...
1
vote
1answer
12 views

Setting up NPS with a certificate that is valid to both AD and non-AD machines

I'm trying to setup an AD server running the NPS service so that both AD and non-AD machines see the certificate as valid when authenticating to the wireless network. I picked up a cert from GoDaddy ...
0
votes
0answers
21 views

I need to enable wifi access through terminal in OS X

I am clearing out an old Mac Lab to recycle the Imacs throughout the organisation. I think my predecessor issued a terminal command to disable wifi access and none will allow the wifi to be active for ...
-1
votes
0answers
18 views

How to troubleshooting wireless network issue with ip-network falling periodically? [migrated]

All wireless clients some times a day can't see anybody in the network: no AP (ping or web-interface), no Internet-access, no each other, but Wi-Fi signal is ok for them. In the same time ...
0
votes
0answers
4 views

Do two computers connected on the same wifi have the same ip address? [migrated]

This question might look stupid but I wondered if two computers connected on the same wifi have the same ip address ? (e.g my dad's computer and my computer, at home) If so, how does the outside ...
0
votes
1answer
46 views

Configure FreeRADIUS with Active Driectory allow specific group of users to authenticate

In order to authenticate WiFi clients I use a FreeRADIUS server configured to check for user credentials in an Active Directory environment. Currently all users with a valid account are authenticated ...
0
votes
0answers
5 views

Wireless 3g dongle not mode-switching successfully [migrated]

Lots of wireless 3G dongles have 2 modes they can operate in; storage mode where they mount like a USB thumb drive and which usually contains Windows drivers for the device, and communication mode. ...
0
votes
1answer
40 views

Port Mirroring to Mac Thunderbolt Ethernet [closed]

I have a switch with port mirroring enabled. So one port is the source port, and the other is the mirror port. In the source port, I have a wifi router plugged in. The mirror port is connected to ...
0
votes
0answers
17 views

Unable to communicate with web proxy server on iOS

I am following the instructions on how to use a HTTP proxy with an iPhone, however I appear unable to communicate with the HTTP proxy. I have configured the settings in my phone correctly to use the ...
0
votes
0answers
4 views

Can AMPDU have different ACK policy MPDUs?

Can an Aggregated packet have different ack policy MPDUs like Normal ACK or Block ACK etc. IEEE802.11 specification defines that MPDUs must have same RA address, same TID, same EOSP and same TXOP ...
-1
votes
2answers
48 views

Wireless adapter driver failure after Windows 8 update

Yesterday we deployed some of the latest Windows 8 and 8.1 updates to our users. One of them did loose network connectivity after the update. It turned out that their wireless adapter's driver was ...
1
vote
1answer
50 views

HTML served from localhost is being modified by ISP [closed]

I took my laptop to a local restaurant yesterday to do some work setting up a new web app. I get the server in place, and created a simple HTML page: <html> <body>Hello, ...
-1
votes
0answers
15 views

Wireless Network card Disconnection while running 4+ VirtualBox instances(bridged) [migrated]

I am running several VMs with VirtualBox using Vagrant to configure and control my test env. Host box is Linux Ubuntu 14.04. I am using a WiFi connection to a Cisco WAP321 and I have the VM boxes ...
2
votes
3answers
87 views

Is there any point securing a “guest” wifi network with WPA?

We have a guest wifi network setup on a separate VLAN, using an open connection (e.g. NO wpa/wep). A (semi-technical) customer recently complained that he wasn't happy about his traffic not being ...
0
votes
0answers
5 views

Why with WAMP utlizes computer name as wireless LAN access not working on Firefox or Safari but Chrome only? [migrated]

I found that when use WAMP on win8, I able to access my wireless LAN like this: if my computer name is mypc, I am able to see the WAMP loitself by type in mypc in the address bar for Chrome. But when ...
2
votes
1answer
100 views

WiFi deauthentication issue

I would like to find a root of the WiFi issue we've got in our working environment. Few words about WiFi infrastructure We are using now Apple solution. Three brand-new access points from Apple ...
0
votes
0answers
22 views

Wireless card fails every three days

I have a user with a brand new Lenovo x240 running windows 7 pro with Eset Endpoint Antivirus and IP Vanish VPN. The user moves between three different work sites on a daily basis, each with it's own ...
0
votes
0answers
50 views

Unable to connect Zentyal 3.2 to WiFi network

I've just installed Zentyal 3.2 as 3.4 wouldn't work with a USB keyboard, and it's all installed fine. However I'm trying to connect my server's wlan0 to my WiFi network so that my laptop can connect ...
-3
votes
0answers
21 views

CISCO SWITCH AND TELNET — 2 [closed]

I need to configure my cisco881 as below after i write "ip address 192.165.1.1 255.255.0.0" the telnet session is disconnected i have ping to 192.165.1.1 but can't access via telnet what should i do ...
0
votes
0answers
53 views

Access switch on the LAN from a WLAN connection Sonicwall TZ205

I have a setup like the following Modem >>> Sonicwall TZ205 >>>> Linksys 8 port smart POE switch >>>> Linksys LRT224 When I am on the LAN through a wired connection ...
3
votes
2answers
102 views

Ensure drive is mapped at login on laptop with strictly wireless

So, $software runs on a 'server' (windows client w/ file sharing to share out the db folder), and laptop client has the drive mapped and $software also installed. This is the vendor's recommended ...
0
votes
0answers
51 views

If I enable bandwidth control on my wifi router can I handle more connections reliably?

I have a small router (TP-Link TL-WR841N) bandwidth is 300 Mbps. With default settings it cannot handle more than 10 connections without choking and kicking people out. Theoretically, however, it can ...
0
votes
0answers
82 views

Cisco WAP321 Access Point Locking Up Daily

We have a Cisco WAP321 Small Business Access Point (WAP321-A-K9 V01 Non Clustered) that has about 15-20 users (Phones and Tablets). The device has been randomly locking up every day to the point ...
0
votes
2answers
71 views

How to get stable WIFI connection between phone and router when thousands of irrelevant phones are around?

I want to use Android phones to check tickets at the gate of an event. These phones are connected to a password protected router (WPA2) and a PC to validate. That all works nicely in a test setting, ...
0
votes
1answer
40 views

Theoretical Wi-Fi decay

Is there a way to (theoretically at least) calculate the decay on bandwith of a Wifi related to the streght signal? For example, I know that I can theoretically expect 54Mbps of a 802.11g at 100%, ...
1
vote
1answer
64 views

Switch to switch encryption over a wireless bridge (TrustSec?)

I am planning to connect an existing Cisco 3750 switch to a 3560C switch over a wireless PTP bridge. The bridge will be WPA2 protected, but I am looking for an additional measure of security between ...
1
vote
1answer
22 views

Access domain A while authenticated against domain B [closed]

In my school, there are 2 domains; A (primary) and B (secondary). A contains the resources required by staff and students. Connecting to the wireless network requires authentication with an account ...
-4
votes
1answer
465 views

Does adding ?.jpg after url really bypasses wifi security? And how? [closed]

So I stumbled upon the following lifehack the other day: I currently don't have access to an airport with expensive WiFi but it seems that adding ?.jpg to any url doesn't cause any problems with ...
0
votes
5answers
544 views

Static ip using a router and DHCP [closed]

I have been trying to understand and achieve assigning a static IP address to my machine, while being connected to a router (WiFi) and using DHCP. My scenario is thus simple, but I think I missing ...
0
votes
0answers
118 views

Is there any way by which I can capture the wifi probe requests without using monitor mode?

For some reason, keeping the wifi interface in monitor mode on my machine is crashing it(its a raspberry pi, I'm assuming its crashing because of the amount of traffic being intercepted, but lets not ...
1
vote
0answers
401 views

How to make a WiFi Hotspot with a captive portal [closed]

I want to create a WiFi Hotspot with a captive portal. The idea is this. want to create a WiFi Hotspot with a captive portal. The idea is this. Internet ...
0
votes
1answer
217 views

Fortinet Fortigate software switch configured IP not accessible

I'm trying to get a software switch configuration working on a Fortigate 100D. It appears like devices plugged into the software switch ports can communicate between each-other, but they cannot reach ...
-2
votes
1answer
213 views

Wireless router URL redirection [closed]

I'm trying to "filter" explicit URLs (+18/21) from network traffic and redirect to another website. I have physical access to router inside my home, computer and router local web-access, which let's ...
2
votes
4answers
197 views

One second delay before tcpdump returns packets

Using Ubuntu, I'm trying to sync tcpdump sniffing with self-identifying "pings" from a client device. The problem is that getting precise starts and stops is made difficult by what looks like a ...
1
vote
0answers
55 views

Wifi between Buildings 385ft Apart [closed]

I administer a network where they've built a new building on the property that is 385ft from the main building. The ground between the buildings is completely paved and the owner wants to avoid a ...
0
votes
2answers
16 views

Access Domain over Wireless

I have an active directory server and all hard wired clients connect perfectly fine. However any wireless clients do not recognize that they are connected to the domain, despite the dns server being ...
-1
votes
1answer
34 views

Reduce unwanted “connect to network” attempts with wireless password [closed]

My university recently added a 5-digit (WEP) network password to their wireless network. (This is in addition to a login page that requires university credentials.) I emailed them, and they said the ...
-2
votes
1answer
135 views

Easiest routing solution for a typical firewall with WiFi routers setup - WAN-2-hops-away network

Suppose a local network connected to the internet via a single firewall router. Devices that connect directly (= using only layer 2 devices) to that router are: hosts WiFi routers providing the ...
0
votes
1answer
43 views

Wifi repeater 3com 7760

I have a problem with a wifi repeater that I am configuring (3Com Wireless 7760) Here some pictures of my installation of the device: https://imgur.com/a/v9uiF According to the manual of the ...
0
votes
0answers
39 views

muliple ssid's on same interface

I am working on centos6. I have 1 wifi interface. Can I create a virtual interface and create an adhoc network with it (my 'real' wifi interface is already connected to another ssid). This is what I ...
1
vote
0answers
16 views

How can I get QoS over a WDS bridge on Cisco WAP551

I have two Cisco WAP551 devices bridging two physical locations wirelessly across the street from each other (200 feet, line-of-sight through a window). This is replacing a much, much older wireless ...
0
votes
1answer
80 views

USB hub or wirless router for synchronizing up to 50 tablets in charging cart

We are building a cart to secure and charge up to 50 Nexus 7 tablets. The tablets need to synchronize databases nightly. Range will not be an issue as the tablets will all be within about 5' of the ...
0
votes
1answer
40 views

Two different SSID's on the same chanel. Is it safe?

If I have multiple network, that have their SSID's on the same channel, can I go into monitor mode(of the wifi interface) and capture packets of the other SSID?
1
vote
2answers
59 views

Restrict access to service to WiFi users

I would like to restrict access to a cloud service based on the network where the requests are coming from. I have control over both the network, and the cloud service receiving requests from within ...
4
votes
1answer
156 views

How does an Access Point handle broadcast packets from the wired side?

I have an Cisco AP 1242AG autonomous AP connected to L2 switches. Let's say I have 100 wired devices each sending 2 broadcast UDP packets per second. Obviously these packets will reach the Access ...
0
votes
1answer
52 views

Connect Multiple Networks Wirelessly [closed]

I have a home network using a router to connect computers both wirelessly and with network cables. I also have another separate network about 10m away from my home network that is networked via ...
0
votes
1answer
68 views

software based captive portal for wide area [closed]

I'm trying to organise some wide wifi network imagine a small town with several wifi points when user is connected to a wifi point, device is redirected to captive-portal(cp) website where they must ...
0
votes
3answers
46 views

s/m business wifi access [closed]

At the moment my company is aiming to split offices. We are in a business park and remaining in the same building, this is only temporary, but several of us are moving into a smaller office about ...
2
votes
1answer
33 views

How to configure an Extreme Networks Altitude 451 for stand-alone AP use?

I have an Extreme Networks Altitude 451 (15801) wireless N access point. It is usually set up and managed using a controller unit, but I am hoping it is possible to configure one of these to work ...